Pioneer VSX-S510-S - Manual (Page 10)

Controls and displays 1 1
10
58
7
4 SB CH (VSX-S510 only) – Press to select ON, AUTO or OFF
the surround back channel ( page 38 ).
CH SEL – Press repeatedly to select a channel, then use
CH LEVEL +/– to adjust the level ( page 52 ).
CH LEVEL +/– – Use to adjust the channel level.
BASS +/– , TRE +/– – Use to adjust Bass or Treble.
• These controls are disabled when the listening mode is
set to DIRECT or PURE DIRECT.
• When the front speaker is set at SMALL in the Speaker
Setting (or automatically via the Auto MCACC setup)
and the X.Over is set above 150 Hz, the subwoofer
channel level will be adjusted by pressing BASS +/–
( page 52 ).
11 DIMMER
Dims or brightens the display. The brightness can be
controlled in four steps.
During ECO mode, the brightness switches between 2 levels.
If the dimmest level is selected, DIMMER will be shown on the
display. (Mode other than ECO: 4 levels, ECO mode: 2 levels)
12  SOURCE
Turn ON/Off the power to the Pioneer device connected to this
unit.
13 ECO
Switches between ECO Mode 1/ECO Mode 2. When ECO
Mode is turned ON, the display will go dark ( page 37 ).
When either of the listening mode button is pressed, ECO
mode turns OFF.
14 Component control buttons
STATUS – Switches the display of this unit.
The listening mode, sound volume, Speaker System (VSX-
S510) setting or input name can be checked by selecting
an input source.
• The Speaker System setting may or may not be
displayed, depending on the input source you have
selected.
SP-A/B – Switch speaker output on/off. When SP OFF is
selected, no sound will be output by the speakers.
PHASE – Press to switch on/off Phase Control ( page 38 ).
SIGNAL SEL – Press to select the audio input signal of the
component to play back ( page 26 ).
15 MUTE
Mutes/unmutes the sound.
16 VOLUME +/–
Use to set the listening volume.
17 DISP
Use to switch the display for Blu-ray discs and DVD.
18 AUDIO
Use to switch the audio for Blu-ray discs and DVD.
Loading the batteries
The batteries included with the unit are to check initial
operations; they may not last over a long period. We
recommend using alkaline batteries that have a longer life.
WARNING
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or catch
fire. It can also reduce the life or performance of batteries.
CAUTION
• Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
- Never use new and old batteries together.
- Insert the plus and minus sides of the batteries properly
according to the marks in the battery case.
- Batteries with the same shape may have different
voltages. Do not use different batteries together.
- When disposing of used batteries, please comply with
governmental regulations or environmental public
institution’s rules that apply in your country/area.
- When inserting the batteries, make sure not to damage
the springs on the battery’s (–) terminals. This can cause
batteries to leak or overheat.
Operating range of remote control
The remote control may not work properly if:
• There are obstacles between the remote control and the
receiver’s remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver is located near a device that is emitting
infrared rays.
• The receiver is operated simultaneously with another
infrared remote control unit.
30°
7 m
30°