Pioneer AVH-3300BT - Manual (Page 45)

Audio Adjustments
Note
When selecting FM as the source, you cannot
switch to
Source Level Adjuster.
Using fader/balance adjustment
You can change the fader/balance setting to
provide an ideal listening environment for all
of the occupied seats.
1 Display the audio function menu.
Refer to Introduction of menu operations on
the previous page.
2 Touch Fader/Balance on the audio func-
tion menu.
3 Touch a or b to adjust the front/rear
speaker balance.
Range:
Front:15 to Rear:15
# Select F/R: 0 L/R: 0 when only using two
speakers.
# The front/rear speaker balance cannot be ad-
justed when the rear output setting is
Subwoofer. Refer to Setting the rear output and
subwoofer controller on page 62.
4 Touch c or d to adjust the left/right
speaker balance.
Range:
Left:15 to Right:15
Using the equalizer
You can adjust the equalization to match the
car
’s interior acoustic characteristics as de-
sired.
Recalling equalizer curves
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves.
Display Equalizer curve
Powerful Powerful
Natural Natural
Display Equalizer curve
Vocal Vocal
Custom1 Custom 1
Custom2 Custom 2
Flat Flat
Super Bass Super bass
! The equalizer curves for Custom1 and
Custom2 can be adjusted.
! You cannot select Custom1 and Custom2
when using the auto-equalizer.
! When Flat, no changes are made to the
sound. You can check the effects of the
equalizer curves by switching alternatively
between
Flat and another equalizer curve.
1 Display the audio function menu.
Refer to Introduction of menu operations on
the previous page.
2 Touch Graphic EQ on the audio function
menu.
# You can select Graphic EQ when Auto EQ
function is off.
3 Touch c or d to select the desired item.
Powerful
—Natural—Vocal—Custom1—
Custom2
—Flat—Super Bass
Adjusting the 8-band graphic equalizer
You can adjust the level of each band for the
equalizer curves.
! A separate Custom1 curve can be created
for each source. If you make adjustments
when a curve other than
Custom2 is se-
lected, the equalizer curve settings will be
recorded in
Custom1.
! A Custom2 curve that is common for all
sources can be created. If you make adjust-
ments when the
Custom2 curve is se-
lected, the Custom2 curve will be updated.
1 Display the audio function menu.
Refer to Introduction of menu operations on
the previous page.
En
45
Section
13
Menu
operations
Menu operations