Pioneer XW-NAS5-S - Manual (Page 17)

Using the tuner 06
17
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 6:
Using the tuner
Connect the FM antenna
Connect the FM antenna plug onto the center pin
of the FM antenna socket.
1
Listening to the FM radio
The tuner can receive FM broadcasts, and lets
you memorize your favorite stations so you
don’t have to manually tune in every time you
want to listen.
1 Press INPUT to switch to the tuner.
The tuner indicator will light, and the tuned
frequency will be displayed.
2 Tune to a station.
There are three ways to do this:
Automatic tuning – To search for
stations, press and hold
TUNE +/– for
about a second. The receiver will start
searching for the next station, stopping
when it has found one. Repeat to search
for other stations.
Manual tuning – To change the frequency
one step at a time, press
TUNE +/–.
High speed tuning – Press and hold
TUNE +/– for high speed tuning. Release
the button at the frequency you want.
Memorizing stations
You can save up to 10 station presets so that
you always have easy access to your favorite
stations without having to tune in manually
each time.
2
1 Press INPUT to switch to the tuner.
2 Tune to an FM radio station.
3 Press TUNER PRESET.
4 Use TUNE +/– to select the station preset
you want (e.g., ‘ ’) then press ENTER.
Listening to station presets
1 Press INPUT to switch to the tuner.
2 Use PRESET +/– to select a station preset.
Note
1 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit.
AC IN
FM UNBAL 75
ANTENNA
FM wire antenna
STANDBY/ON
INPUT
PRESET PRESET
ENTER
SLEEP
CLOCK SETUP
WAKE
UP
TUNER
PRESET
BASS/
TREBLE
TUNE
TUNE
2 When a new broadcast frequency is stored in a station containing a previously stored frequency, the previous frequency will
be overwritten with the new one.
XW-NAS5_SYXJ.book 17 ページ ２００９年８月７日 金曜日 午前１０時１４分