What’s in the box, Before using the remote control, Replace the battery – Pioneer XW-NAS5-S User Manual

Page 5: Before you start, Before you start 01, Chapter 1

Advertising
background image

Before you start

01

5

En

English

Français

Deutsch

Nederlands

Italiano

Español

Chapter 1:

Before you start

What’s in the box

Please confirm that the following accessories
are in the box when you open it.

• Remote control

• Remote control holder

• Lithium battery (CR2025)

• FM wire antenna

• Power cord

• Warranty card

• Operating instructions (This document)

Before using the remote control

The remote control is shipped already set in the
remote control holder.

The battery supplied with this unit is stored in
the battery casing.

Remove the protective seal from the

battery casing.
When you notice a decrease in the operating
range, replace the battery (see below).

Replace the battery

When replacing the battery, use a
commercially available Lithium CR2025
battery.

1

Push the release tab to the left to open

the battery casing.

2

Pull out the battery casing.

3

Remove the battery from the casing.

4

Place a new battery in the casing.

Make sure the

 side of the battery is facing

up when you place it in the space provided.

Caution

When using lithium batteries, please observe
the following:

• There is danger of explosion if the battery is

incorrectly replaced. Make sure to replace
only with the same or equivalent type
recommended by the manufacturer.

• Dispose of used battery cells immediately

after replacement. Keep away from
children.

• If swallowed, please contact a doctor

immediately.

• Lithium batteries may present a fire or

chemical burn hazard if misused. Do not
disassemble, heat above 100 °C, or
incinerate.

1

1

3

2

XW-NAS5_SYXJ.book 5 ページ 2009年8月7日 金曜日 午前10時14分

Advertising
This manual is related to the following products: