01 enjoying dtv broadcasts, Dtv programme timer setting, Setting up digital tv channels manually – Pioneer PDP-435XDE User Manual
Page 5: English
01
Enjoying DTV broadcasts
English
5
En
DTV Programme Timer Setting
With the Programme Timer list you can sort the order of
programmes or delete programmes that are preset for
recording/watching.
1
Press HOME MENU.
2
Select “Setup” ( / then ENTER).
3
Select “DTV Setup” ( / then ENTER).
4
Select “Programme Timer” ( / then ENTER).
5
Set the start and end time of preset recording/watching
and the channel number ( / ,
/
or 0 – 9). Register
after all desired settings are made (ENTER).
Setting up digital TV channels manually
This section describes how to add new digital TV channels.
Adding New Channels
You can scan the new TV channels and download them to
your Plasma Display System.
1
Press HOME MENU.
2
Select “Setup” ( / then ENTER).
3
Select “DTV Setup” ( / then ENTER).
4
Select “Installation” ( / then ENTER).
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
5
Select “Add New Channels” ( / then ENTER).
Checking signal strength
You can check the signal strength and signal quality of each
TV channel.
1
Repeat steps 1 to 4 provided for Adding New
Channels.
2
Select “Signal Check” ( / then ENTER).
3
Select “RF Channel” ( / then ENTER).
4
Select the channel to be checked (
/
).
• Use “Add New Channels” function here to add
channels within the selected RF Channel (receiving
frequency).
• Channel search automatically starts.
Installation
Country
Add New Channels
Aerial Power
Replace Existing Channels
Restore System Defaults
Signal Check
Off
Germany
Signal Check
Signal Strength
0
25
50
75
100
Signal Quality
Add New Channels
77%
100% Good
:
:
RF Channel
21
Installation
Country
Add New Channels
Aerial Power
Replace Existing Channels
Restore System Defaults
Signal Check
Germany
Off
• To quit a channel search in progress, press HOME
MENU.
Add New Channels
Existing Channels
04
New Channels Found
Search Information
Progress
20
30%
001
002
Found Channels
003
004
************
************
******
************
Restoring System Defaults
Use this function only when you wish to reset all the DTV
settings to the factory defaults.
1
Press HOME MENU.
2
Select “Setup” ( / then ENTER).
3
Select “DTV Setup” ( / then ENTER).
4
Select “Installation” ( / then ENTER).
• The password entry screen appears. Enter your 4-digit
password using buttons 0 – 9.
5
Select “Restore System Defaults” ( / then ENTER).
• A confirmation screen appears.
6
With “OK” pressed, the system restores the factory
defaults. After this Auto Installation is initiated
automatically.
Setting Aerial Power
The power supply to the antenna connected to the DTV
antenna terminal can be switched on or off.
1
Repeat steps 1 to 4 provided for Adding New
Channels.
2
Select “Aerial Power” ( / ).
3
Select “On” or “Off” (
/
).