Pioneer KRL-32V - Manual (Page 13)

Confirm that there are ten screws with the stand
unit.
Attach the supporting post for the stand unit
onto the base using the six screws with the
screw driver (supplied) as shown.
1
2
Preparation
Inserting the stand.
Insert the stand into the openings on the
bottom of the TV (Hold the stand so it will
not drop from the edge of the base area).
Insert and tighten the four short screws into
the four holes on the rear of the TV.
3
1
2
1
2
NOTE
To detach the stand unit, perform the steps in reverse
order. •
Supplied accessories
Attaching the stand unit
Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent
it from being damaged.
CAUTION
Attach the stand in the correct direction.
Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
•
•
•
•
10
Remote control unit
( g1)
AC cord ( g2) Stand unit ( g1) Cable clamp ( g1)
Pages 3 and 11 Page 10 Page 14 Page 14
Operation manual (This publication)
Warranty card •
• “AA” size alkaline battery ( g2) ... Page 11 •
SOURCE TV STB DVR VCR DVD SELECT
HOME MENU
MENU
RETURN
EXIT DVD TOPMENU/ GUIDE EPG
P
4 5 6
7 8 9
0 P.INFO
1 2 3
INFO
CH RETURN
TV
CTRL HDMI REC STOP
HDD AV SELECTION CM SKIP DVD TOOLS SCREEN SIZE
DTV RADIO
1 2 3 4
5 6 7 8
TV
INPUT
ENTER
Supporting
post
Soft
cushion
KRL3237V_GB.indd 10 KRL3237V_GB.indd 10 2008/06/13 14:49:35 2008/06/13 14:49:35