Pioneer DEH-P6900IB - Manual (Page 29)

Initial Settings
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 1 1
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press MULTI-CONTROL and hold until
Language select appears in the display.
# You can also perform this operation by press-
ing and holding
FUNCTION on the remote con-
trol.
3 Turn MULTI-CONTROL to select one of
the initial settings.
Turn
MULTI-CONTROL to switch between the
functions in the following order:
Language select (language selection)
—Clock
(clock)
—Off clock (off clock)—FM step (FM
tuning step)
—Auto PI (auto PI seek)—
Warning tone (warning tone)
—AUX1 (auxili-
ary input 1)
—AUX2 (auxiliary input 2)—
Dimmer (dimmer)
—Brightness (brightness)
—S/W control (rear output and subwoofer
controller)
—Mute (sound muting/attenua-
tion)
—Demonstration (feature demo)—
Reverse mode (reverse mode)
—Ever-scroll
(ever scroll)
—BT AUDIO (Bluetooth audio)—
Pin code input (pin code input)
Use the following instructions to operate each
particular setting.
# You can also select the function by pressing
FUNCTION on the remote control.
# BT AUDIO and Pin code input can be se-
lected only when Bluetooth adapter (e.g., CD-
BTB100) is connected to this unit.
# To cancel initial settings, press BAND.
Selecting the display language
For your convenience, this unit equips multi-
ple language display. You can select the lan-
guage best suited to your first language.
1 Use MULTI-CONTROL to select
Language select.
2 Press MULTI-CONTROL to select the lan-
guage.
Each press of
MULTI-CONTROL selects lan-
guages in the following order:
English
—Français—Italiano—Español—
Deutsch
—Nederlands—РУССКИЙ
Setting the clock
Use these instructions to set the clock.
1 Use MULTI-CONTROL to select Clock.
2 Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing
MULTI-CONTROL left or right will se-
lect one segment of the clock display:
Hour
—Minute
As you select segments of the clock display
the segment selected will blink.
3 Push MULTI-CONTROL up or down to
put a clock right.
Note
You can match the clock to a time signal by
pressing
MULTI-CONTROL.
! If the minute is 00 to 29, the minutes are
rounded down. (e.g., 10:18 becomes 10:00.)
! If the minute is 30 to 59, the minutes are
rounded up. (e.g., 10:36 becomes 11:00.)
Operating this unit
En
29
English
Section
02