Pioneer AVH-5200DVD - Manual (Page 62)

Bluetooth
Message Cause Action
Error-10 The power failed
for the Bluetooth
module of this
unit. Turn the ignition
switch OFF and
then to ACC or ON.
If the error mes-
sage is still dis-
played after
performing the
above action,
please contact
your dealer or an
authorized Pioneer
Service Station.
Understanding auto EQ
error messages
When correct measurement of the car
’s inter-
ior acoustic characteristics is not possible
using auto EQ, an error message may appear
on the display. In such cases, refer to the table
below to see what the problem is and how it
may be corrected. After checking, try again.
Message Cause Action
Error. Please
check MIC. The microphone
is not connected. Plug the optional
microphone se-
curely into the
jack.
Error. Please
check xxxx
speaker. The microphone
cannot pick up
the measuring
tone of a speaker.
! Confirm that the
speakers are con-
nected correctly.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Plug the micro-
phone securely
into the jack.
Error. Please
check noise. The surrounding
noise level is too
high.
! Stop your car in
a place that is
quiet, and switch
off the engine, air
conditioner and
heater.
! Set the micro-
phone correctly.
Message Cause Action
Error. Please
check battery. Power is not
being supplied
from the battery
to this unit. ! Connect the bat-
tery correctly.
! Check the battery
voltage.
En
62
Appendix
Additional Information