Pioneer DEH-X9500BT - Manual (Page 22)

Pause (pause)
1 Press M.C. to pause or resume.
Sound Retriever (sound retriever)
1 Press M.C. to select the desired setting.
1 —2—OFF (off)
1 is effective for low compression rates, and 2 is
effective for high compression rates.
Audio adjustments
1 Press M.C. to display the main menu.
2 Turn M.C. to change the menu option
and press to select AUDIO.
3 Turn M.C. to select the audio function.
Once selected, the following audio functions
can be adjusted.
! The cut-off frequency and output level can
be adjusted when the subwoofer output is
on.
! SLA is not available when FM is selected as
the source.
Fader/Balance (fader/balance adjustment)
1 Press M.C. to display the setting mode.
2 Press M.C. to cycle between fader (front/rear) and
balance (left/right).
3 Turn M.C. to adjust the front/rear speaker bal-
ance.
Turn
M.C. to adjust the left/right speaker balance.
Preset EQ (equalizer recall)
1 Press M.C. to display the setting mode.
2 Turn M.C. to select an equalizer curve.
Powerful —Natural—Vocal—Custom1—Cus-
tom2 —Flat—SuperBass
G.EQ (equalizer adjustment)
You can adjust the currently selected equalizer curve
setting as desired. Adjusted equalizer curve settings
are stored in
Custom1 or Custom2.
! Custom1 can be set separately for each source.
However, each of the below combinations are set
to the same setting automatically.
! USB, iPod, SD, and Apps (iPhone)
! BT Audio, and Apps (Android)
! Custom2 is a shared setting used in common for
all sources.
1 Press M.C. to display the setting mode.
2 Press M.C. to cycle between the following:
Equalizer band —Equalizer level
3 Turn M.C. to select the desired setting.
Equalizer band: 100Hz
—315Hz—1.25kHz—
3.15kHz —8kHz
Equalizer level: +6 to –6
Loudness (loudness)
Loudness compensates for deficiencies in the low-fre-
quency and high-frequency ranges at low volume.
1 Press M.C. to display the setting mode.
2 Press M.C. to turn loudness on or off.
3 Turn M.C. to select the desired setting.
Low (low) —Mid (mid)—High (high)
Subwoofer1 (subwoofer on/off setting)
This unit is equipped with a subwoofer output which
can be turned on or off.
1 Press M.C. to display the setting mode.
2 Press M.C. to turn subwoofer output on or off.
3 Turn M.C. to select the phase for the subwoofer
output.
Turn
M.C. to the left to select reverse phase, and
Reverse appears in the display. Turn M.C. to the
right to select normal phase, and
Normal appears
in the display.
Subwoofer2 (subwoofer adjustment)
Only frequencies lower than those in the selected
range are outputted from the subwoofer.
1 Press M.C. to display the setting mode.
2 Press M.C. to cycle between the cut-off frequency
and the output level for the subwoofer.
3 Turn M.C. to select the cut-off frequency.
50Hz —63Hz—80Hz—100Hz—125Hz
4 Turn M.C. to adjust the output level for the sub-
woofer.
+6 to
–24 is displayed as the level is increased or
decreased.
Bass Booster (bass boost)
En
22
Section
02 Using this unit