Pioneer DEH-X9500BT - Manual (Page 28)

4 Turn M.C. to select the set up menu
function.
Once selected, the following set up menu
functions can be adjusted.
! Software Update is not available for DEH-
X9500SD.
FM step (FM tuning step)
Normally, the FM tuning step setting used for seek
tuning is 50 kHz. The tuning step changes to 100 kHz
automatically when the alternative frequencies
search or traffic announcement standby function is in
use. It may be preferable to set the tuning step to
50 kHz when the alternative frequencies search func-
tion is on.
1 Press M.C. to select the FM tuning step.
50kHz (50 kHz)
—100kHz (100 kHz)
S/W control (rear output and subwoofer setting)
This unit
’s rear output (rear speaker leads output and
RCA rear output) can be used for full-range speaker
(
Rear SP :F.Range) or subwoofer (Rear SP :S/W) con-
nection. If you switch the rear output setting to Rear
SP :S/W, you can connect a rear speaker lead directly
to a subwoofer without using an auxiliary amp.
1 Press M.C. to switch the rear output setting.
! When no subwoofer is connected to the rear
output, select Rear SP :F.Range (full-range
speaker).
! When a subwoofer is connected to the rear
output, select Rear SP :S/W (subwoofer).
! Even if you change this setting, there will be no
output unless you turn the subwoofer output on
(refer to
Subwoofer1 (subwoofer on/off setting)
on page 22).
! If you change this setting, subwoofer output in
the audio menu will return to the factory settings.
! Both rear speaker lead outputs and RCA rear out-
put are switched simultaneously in this setting.
Software Update (updating the software)
This function is used to update this unit with the lat-
est Bluetooth software. For about Bluetooth software
and updating, refer to our website.
! Never turn the unit off while the Bluetooth soft-
ware is being updated.
1 Press M.C. to display the data transfer mode.
Follow the on-screen instructions to finish updat-
ing the Bluetooth software.
System menu
1 Press and hold SRC/OFF until the unit
turns off.
2 Press and hold M.C. until the main
menu appears in the display.
3 Turn M.C. to change the menu option
and press to select SYSTEM.
4 Turn M.C. to select the system menu
function.
For details, refer to System menu on page
26.
Using an AUX source
1 Insert the stereo mini plug into the
AUX input jack.
2 Press SRC/OFF to select AUX as the
source.
Note
AUX cannot be selected unless the auxiliary set-
ting is turned on. For more details, refer to
AUX
(auxiliary input) on the previous page.
If an unwanted display
appears
Turn off the unwanted display using the proce-
dures listed below.
1 Press M.C. to display the main menu.
2 Turn M.C. to change the menu option
and press to select SYSTEM.
3 Turn M.C. to display DEMO OFF and
press to select.
4 Turn M.C. to switch to YES.
5 Press M.C. to select.
En
28
Section
02 Using this unit