Pioneer AVIC-F20BT - Manual (Page 137)

Setting the rear output
The navigation system
’s rear output can be
used for a full-range speaker or subwoofer
connection. If you switch
Rear SP to Sub. W,
you can connect a rear speaker lead directly to
a subwoofer without using an auxiliary amp.
Initially, the navigation system is set for a rear
full-range speaker connection (
Full).
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
p “Rear SP” can be set only when the source
is selected to
“Off”.
1 Display the
“AV System Settings”
screen.
= For details, refer to Displaying the “AV Sys-
tem Settings ” screen on page 135.
2 Touch [Rear SP].
Each touch of [ Rear SP] changes the settings
as follows:
! Full
When no subwoofer is connected to the
rear output, select
“Full”.
! Sub. W
When a subwoofer is connected to the rear
output, select
“Sub. W”.
Switching the muting/
attenuation timing
You can mute the AV source volume or attenu-
ate the output signal. This setting is invalid for
the mute signal that has been received from
the MUTE lead connected to the navigation
unit. (Even if this setting is
“Off”, the naviga-
tion system will mute or attenuate the audio
source volume when the signal is output via
MUTE lead.)
1 Display the
“AV System Settings”
screen.
= For details, refer to Displaying the “AV Sys-
tem Settings
” screen on page 135.
2 Touch [Mute].
Each touch of [ Mute] changes the settings as
follows:
! Guide/Tel: The volume is muted or attenu-
ated according to the following conditions.
— When the navigation outputs the gui-
dance voice.
— When you use a mobile phone via Blue-
tooth technology (dialling, talking, in-
coming call).
! Tel: The volume is muted or attenuated
when you use a mobile phone via Bluetooth
technology (dialling, talking, incoming call).
! Off: The volume does not change.
p AV source volume returns to normal when
the corresponding action is ended.
Switching the muting/
attenuation level
You can select the muting/attenuation level of
“Mute”. This setting is also effective for a
mute signal that has been received from the
MUTE lead connected to the navigation unit.
p This menu is not available when AV source
is
“Off”.
1 Display the “AV System Settings”
screen.
= For details, refer to Displaying the “AV Sys-
tem Settings
” screen on page 135.
2 Touch [Mute Level].
Each touch of [ Mute Level] changes the set-
tings as follows:
! 20dB: The volume becomes 1/10.
! 10dB: The volume becomes 1/3.
! All: The volume becomes 0.
p When you select “All”, no audio adjust-
ments are possible during the sound is
turned off.
p When you select “20dB” or “10dB”, no
audio adjustments are possible during the
sound is attenuated.
p AV source volume returns to normal when
the corresponding action is ended.
Engb
137
Chapter
26
Customising
pr
eferences
Customising preferences