Pioneer AVIC-HD3-II - Manual (Page 13)

Power cord
Violet/white (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system
can detect whether the vehicle is moving
forwards or backwards. Connect the
violet/white lead to the lead whose voltage
changes when the reverse gear is engaged.
Unless connected, the sensor may not detect
your vehicle travelling forward/backward
properly, and thus the position of your vehicle
detected by the sensor may be misaligned from
the actual position.
When you use the ND-PG1 speed pulse
generator (sold separately), please make sure to
connect this lead. When you use a rear view
camera, please make sure to connect this lead.
Otherwise you cannot switch to rear view camera
picture.
Be sure to use only the supplied extension lead. Use of another
lead could cause fire, smoke and/or damage this navigation
system.
Connection method
Check the position of your
vehicle´s reversing lamp (the one
that lights up when the gearstick is
in reverse [R]) and find the
reversing lamp lead in the boot.
Extension lead
(for reverse signal)
Extension lead (for speed signal)
The navigation unit
5 m
Fuse resistor
Reversing
lamp lead
Clamp the reversing
lamp lead.
Clamp firmly with
needle-nosed
pliers.
Note
CAUTION
20 cm
RCA
connector 2
Yellow/black (GUIDE ON)
When combining this navigation system with the other
Pioneer audio unit for the vehicle, if the vehicle stereo has
yellow/black leads, connect them to those leads. In this
way, the vehicle stereo is automatically muted to reduce
the vehicle stereo volume when;
- the guidance audio is output.
- the mobile phone is used via Bluetooth unit.
- you operate the system by voice.
Connecting the System
Engb
13
English
Section
02