Adjusting the time alignment 83, Using subwoofer output, Audio adjustments – Pioneer DEH-P9800BT User Manual
Page 83
Adjusting the time alignment
You can adjust the distance between each
speaker and the selected position.
! An adjusted time alignment is memorized
in
Custom.
1
Use MULTI-CONTROL to select
TA Mode.
TA Mode appears in the display.
2
Press MULTI-CONTROL to select a unit
of distance.
Each press of
MULTI-CONTROL selects the
unit of distance in the following order:
cm (centimeter)
—inch (inch)
3
Use MULTI-CONTROL to select
Time Alignment.
Time Alignment appears in the display.
# Can't adjust TA. Set position FL/FR appears
when neither
Front Left nor Front Right is se-
lected in the position selector mode (
Position).
# When selecting OFF in TA Mode, you cannot
switch to
Time Alignment.
4
Push MULTI-CONTROL left or right to
select the speaker to be adjusted.
Each time
MULTI-CONTROL is pushed left or
right, the speaker is selected in the following
order:
6
6
6
1
1
1
1
2
2
2
2
3
3
3
4
4
4
5
5
5
1 Front speaker left
2 Front speaker right
3 Rear speaker right
4 Subwoofer right
5 Subwoofer left
6 Rear speaker left
Front speaker left
—Front speaker right—Rear
speaker right
—Rear speaker left—Subwoofer
left
—Subwoofer right
# You cannot select subwoofer left and subwoo-
fer right when the subwoofer output is off.
5
Push MULTI-CONTROL up or down to
adjust the distance between the selected
speaker and the listening position.
Each time
MULTI-CONTROL is pushed up or
down, the distance increases or decreases.
400.00cm to 0.00cm is displayed as the dis-
tance is increased or decreased, if you have
selected centimeters (
cm).
160.0inch to 0.0inch is displayed as the dis-
tance is increased or decreased, if you have
selected inches (
inch).
# You can adjust the distance for the other
speakers in the same way.
6
Press BAND to cancel the time align-
ment mode.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off. When a sub-
woofer is connected to this unit, turn the sub-
woofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1
Use MULTI-CONTROL to select
Subwoofer1.
Subwoofer1 appears in the display.
2
Press MULTI-CONTROL to turn subwoo-
fer output on.
ON appears in the display. Subwoofer output
is now on.
# To turn subwoofer output off, press
MULTI-CONTROL again.
Audio Adjustments
En
83
English
Section
14