Pioneer DEH-P9800BT - Manual (Page 84)

3 Push MULTI-CONTROL left or right to
select stereo or monaural.
Push
MULTI-CONTROL left to select monaural
and MONO appears in the display. Push
MULTI-CONTROL right to select stereo and
STEREO appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use MULTI-CONTROL to select
Subwoofer2.
Subwoofer2 appears in the display.
# When the subwoofer output is on, you can se-
lect
Subwoofer2.
2 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time
MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50
—63—80—100—125—160—200 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
Each time
MULTI-CONTROL is pushed up or
down, subwoofer level increases or decreases.
+6 to
–24 is displayed as the level is increased
or decreased.
Adjusting low pass filter
attenuation slope
When the subwoofer output is on, you can ad-
just the continuity of sound between speaker
units.
1 Use MULTI-CONTROL to select
Subwoofer3.
Subwoofer3 appears in the display.
# When the subwoofer output is on, you can se-
lect
Subwoofer3.
2 Push MULTI-CONTROL up or down to
select the phase of subwoofer output.
Push
MULTI-CONTROL up to select normal
phase and appears in the display. Push
MULTI-CONTROL down to select reverse
phase and
appears in the display.
3 Push MULTI-CONTROL left or right to
select slope.
Each time
MULTI-CONTROL is pushed left or
right, slopes are selected in the following
order:
–18— –12— –6 (dB/oct.)
Note
When slope of subwoofer and high pass filter are
–12dB, and same cut-off frequency, the phase is
reversed 180 degrees at the cut-off frequency. In
this case, reversing the phase assures improved
sound continuity.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
Muting the speaker units (filters)
You can mute front and rear speaker units (fil-
ters) separately. When speaker units (filters)
are muted, no sound is outputted from those
speakers.
Audio Adjustments
En
84
Section
14