Pioneer PDP-507XA - Manual (Page 18)

18
En
Preparation 05
Attaching speed clamps to the main unit
Attach the speed clamps using the 3 holes (42 inches: 2 holes)
marked with below, depending on your routing system.
for PDP-507XA
for PDP-427XA
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the Plasma
Television and snap [2] into the back of [1] to lock the clamp.
Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
Be careful not to subject any connecting cables to strain.
NOTE
• Use the supplied speed clamps as necessary.
Connecting to an antenna
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used
for a coaxial cable.
Antenna cable (commercially available)
3 4
• For viewing broadcasts, connect the 75-ohm
coaxial cable (commercially available) to ANT
(analogue input) terminal.
Viewed from below of
the display
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a standard
DIN45325 plug (IEC169-2), plug it into the antenna terminal at the rear of
the Plasma Television.
PDP507XA.book Page 18 Tuesday, June 20, 2006 1:44 PM