Pioneer CNSD-210FM - Manual (Page 35)

Problems in the procedures for updating
Symptom Cause Action
The upgrade process doesn
’t
start and the navigation system
boots up as usual.
An incorrect microSD card has
been inserted. Eject the inserted microSD card and insert
the correct upgrade microSD card.
Upgrade has been already done. Check whether the upgrade was done prop-
erly. If the upgrade has not been done yet,
consult the nearest authorised service sta-
tion.
The screen that cannot begin the
upgrade process is displayed. Eject the upgrade microSD card #1 (8 GB),
and display the map of your current position,
and then reinsert the upgrade microSD card
#1 (8 GB).
The navigation system does not
work properly after upgrade. The engine of your vehicle was
stopped or the power supply to the
navigation system was turned off
during upgrade process. Consult the nearest authorised service sta-
tion.
Upgrade microSD card was pulled
out during upgrade process. Consult the nearest authorised service sta-
tion.
Messages in the procedures for updating
The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Message When What to do
An error occurred and the up-
date failed. Unexpected error occurred in the
update process. Consult your local Pioneer dealer if this mes-
sage persist.
Engb
35
Appendix
Tr
oubleshooting
Troubleshooting