Pioneer DJM-600 - Manual (Page 21)

21
<DRB1251>
1 4
70-139
BPM
91-180
BPM
BPM
3
AUTO BPM COUNTER
2
1
MASTER
4 MIC
mSec
3
PARAMETER1
2
1/2 1/1 4/1 2/1 3/4
1 4
BEAT
16 8 2
USING THE EFFECT/SAMPLER FUNCTIONS
Using Sampler Playback Functions
Following are the three available methods for playing back the sound recorded with the unit’s built-in sampler.
SINGLE PLAY
LOOP PLAY
STRETCH LOOP PLAY
Plays only while the effect/sampler ON/OFF is being pressed.
Repeatedly plays the recorded sound.
Based on the BPM of the music to be mixed, repeatedly plays the sound recorded within the set
number of beats (1, 2, 4, 8, or 16). The recorded sound will be played stretched to match the set
number of beats.
Example: Mixing stretch loop play of recorded music with music on CH-2 (BPM=130).
1 Set the effect/sampler selector switch to
STRETCH LOOP PLAY.
÷ The effect/sampler ON/OFF switch will light green.
2 Set the effect/sampler channel selector switch
to 2.
÷ LED “2” on the effect parameter/BPM display will light.
÷ The BPM of the music input to CH-2 will be displayed
on the BPM display’s counter.
* The BPM band that matches the music on CH-2 can be
selected with the BPM measurement range selector
switch.
* LED will blink if BPM cannot be measured for more
than 2 seconds. In this case, use manual mode to make
settings (see page 15).
3 Set the playback time and playback level.
÷ Press the effect beat selector switch and “8” will light
on the beat display.
* To set the playback time more precisely, use the effect/
sampler parameter 1 knob (TIME). The time that was
set will be displayed on the effect parameter/BPM
display. Playback time ranges from 10 to 16,000msec.
* The playback level is set using the effect/sampler
parameter 2 knob (LEVEL/DEPTH).
4 Set the effect/sampler ON/OFF switch to ON.
¶ When playback begins, the effect/sampler ON/OFF
switch will blink green.
BPM display
Effect parameter/
BPM display
Counter
Counter
BPM measurement
range selector
switch
LED
Beat display
Effect beat selector
switch
Using Sampler Edit Function
Use the sampler housed inside the unit to set the position
where playback of the recorded sound is completed.
1 Set the effect/sampler selector switch to EDIT.
÷ The effect sampler ON/OFF switch will light in green.
2 Set the effect/sampler ON/OFF switch to ON.
÷ When playback begins, the effect/sampler ON/OFF
switch will blink green.
3 Set the playback stop position.
÷ While monitoring the loop playback sound, set the
playback completion position (loop end point) with the
effect/sampler parameter 1 knob (TIME). The time that
was set will be displayed on the effect parameter/BPM
display.
* It is impossible to set it longer than the time that was
recorded.