Pioneer VSX-LX70 - Manual (Page 73)

Using other functions 12
73
En
1 During recording, press the REC SELECT CONTROL
button on the front panel until RECOUT shows in the
display.
1
2 While RECOUT shows in the display, use the
INPUT SELECTOR dial to select the source you want
to record.
The default,
RECOUT SOURCE, records the source you’re
currently listening to (as in Press RETURN to confirm and
exit the menu. above).
• Note that the setting you make here is stored in
memory, even if you switch off the receiver, so if you
want to record a different input source later, you
must do so with
REC SELECT, or by selecting
RECOUT SOURCE.
3 After RECOUT disappears from the display, select
the input source you want to listen to.
This will be heard from the main system without affecting
your recording.
2
Reducing the level of an analog signal
The input attenuator lowers the input level of an analog
signal when it’s too strong. You can use this if you find
the that the
OVER indicator is lights often, or you can
hear distortion in the sound. 3
• Press ANALOG ATT to switch the input attenuator
on or off.
Using the sleep timer
The sleep timer switches the receiver into standby after a
specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use
the remote control to set the sleep timer.
• Press SLEEP repeatedly to set the sleep time.
• You can check the remaining sleep time at any time
by pressing SLEEP once. Pressing repeatedly will
cycle through the sleep options again. 4
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
• Press DIMMER repeatedly to change the brightness
of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω impedance rating.
1 With the receiver in standby, press  STANDBY/
ON while holding down the SETUP button.
2 Select SPEAKER using /, then select 8 Ω or 6 Ω
using /.
• SPEAKER 6 Ω – Use this setting if your speakers are
rated at 6
Ω.
• SPEAKER 8
Ω – Use this setting if your speakers are
rated at 8
Ω or more.
Note
1 If RECOUT does not appear in the display, you may have to switch ZONE 2 off by pressing MULTI ZONE & SOURCE ON/OFF and selecting either
ZONE 3 or off (the MULTI-ZONE indicator disappears). See Using the MULTI-ZONE controls on page 60 for more on this.
2 If
RECOUT SOURCE is selected, changing the input source likewise changes the input source used for your recording.
3 The attenuator isn’t available with digital sources, or when using the Stream Direct modes.
SLEEP
SR+
ANALOG
ATT
SC
DIMMER
CLASS D.ACCESS
GENRE
SLEEP
SR+
ANALOG
ATT DIMMER
CLASS D ACCESS
GENRE
Off
30 min 60 min
90 min
4 You can also switch off the sleep timer simply by switching off the receiver.
SLEEP
SR+
ANALOG
ATT DIMMER
CLASS D.ACCESS
GENRE
VSX_LX60LX70.book Page 73 Wednesday, June 6, 2007 3:13 PM