Pioneer VSX-LX70 - Manual (Page 88)

Additional information 14
88
En
USB interface (VSX-LX60 only)
iPod messages
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Symptom Remedy
USB mass storage device is not
recognized by the receiver. • Try switching the receiver off, then on again.
• Make sure you have completely inserted the USB connector to this receiver.
• Check that the memory format is FAT16 or FAT32 (FAT12, NTFS and HFS are not supported).
• USB devices with an internal USB hub are not supported.
USB ERR3 shows in the display
when connecting a USB device. • If this message continues to appear after going through all the checks in Important on page 35 of USB
playback, take the unit to your nearest Pioneer authorized service center or your dealer for servicing.
Can’t play audio files. • The WMA or MPEG-4 AAC files were recorded using DRM (digital rights management), or the bit rate/
sampling rate is not compatible (see
Compressed audio compatibility on page 35). This is not a
malfunction.
Symptom Cause Action
Error I1 There is a problem with the signal path from the
iPod to the receiver. Switch off the receiver and reconnect the iPod to the receiver.
If this doesn’t seem to work, try resetting your iPod.
Error I2 The software version being used with the iPod
needs to be updated. Update the software being used with the iPod (please use the
latest iPod software versions later than the iPod updater 2004-
10-20).
No Music Track There are no playable songs currently stored in
the iPod. Input some music files compatible with iPod playback.
Loading Error There is no responce from the iPod. Update the software being used with the iPod (please use the
latest iPod software versions later than the iPod updater 2004-
10-20).
VSX_LX60LX70.book Page 88 Wednesday, June 6, 2007 3:13 PM