Pioneer CDJ-2000NXS - Manual (Page 19)

19 En
Part
names
and
functions
Rear panel
POWER
CONTROL
1 2
For the terminals used for connections, see Descriptions of terminals
on page 12. 1 POWER ON/OFF button
Press to turn the power on and off.
2 Kensington security slot
Front panel
1 2 3
1 Disc insertion slot
2 Disc force eject pin insertion hole
3 Disc insertion slot indicator
About ejecting discs by force
! If the disc cannot be ejected by pressing the [DISC EJECTh] button, the disc can be forcibly ejected by inserting the disc force eject pin into the disc
force eject pin insertion hole on the main unit’s front panel.
! When forcibly ejecting a disc, be sure to do so following the procedure below.
1 Press the [POWER ON/OFF] button to turn this unit’s power off, then wait at least 1 minute.
Never forcibly eject a disc directly after turning off the set’s power. Doing so is dangerous for the reasons described below.
The disc will still be spinning when ejected and could hit your fingers, etc., causing injury.
Also, the disc clamp will rotate in an unstable way, and the disc could get scratched.
2 Use the included disc force eject pin. (Do not use anything else.)
The included disc force eject pin is mounted on this unit’s bottom panel. When the pin is inserted all the way into the insertion hole, the disc is ejected
5 mm to 10 mm out of the disc insertion slot. Grasp the disc with your fingers and pull it out.