Pioneer PDK-TS25 - Manual (Page 17)

17
En
English
10
˚
10
˚
Installing the Product on a TV table etc.
Be sure to observe the following precautions when moving
or installing this product with a Plasma Display into a TV
table or other enclosure.
Precautions when moving
When moving the product more than a few
meters, first remove the speaker, then remove
the Plasma Display from the stand and move the
speaker, Plasma Display, and stand separately.
When detaching the Plasma Display from the
stand, be sure to follow the procedure described
in “Detaching the Plasma Display from the
Stand” on page 20.
Precautions when installing in a TV
table or other enclosure
When installing in a TV table or other enclosure, hold
the Plasma Display by the handles located on the rear
of the Plasma Display. If you hold the speakers, they
may be damaged or twisted.
When the plasma display you have purchased is
PDP-507XD/507XA(under speaker models).
Hold the Plasma Display by its handles and from the sides.
Installation precautions
Make sure that you always secure a space at least as large
as that shown in the following diagram in front of and
behind the table top stand.
If the stand protrudes from the TV table, it could
cause unforeseen accidents such as the equipment
breaking or falling over.
When rotating, take care not to allow the display
to bump into walls or surrounding objects.
Range of angle rotation
Caution
Caution
Caution
Protrusion is dangerous.
When the plasma display you have purchased is
PDP-507XD/507XA(except under speaker models)/
PDP-427XD/427XA.
Hold the Plasma Display by its handles and from the
bottom.
under speaker
Min. 10 mm (13/32 inch)
Plasma Display
TV table
Table top stand
Min. 30 mm (1-3/16 inch)
Back
Depth of the TV table 420 mm (16-9/16 inch) or more recommended
Front
Min. 30 mm
(1-3/16 inch)
Min. 30 mm
(1-3/16 inch)