Pioneer PDK-TS25 - Manual (Page 20)

20
En
Detaching the Plasma Display from the Stand
To remove the Plasma Display from the stand, be sure
to always follow the procedure described below to
prevent accidents.
1
First, confirm that the forward/backward
inclination anchor bolt is securely
tightened.
2
First clear a space on a flat floor etc. where
you can lay the Plasma Display flat, then
lay a sheet to protect it from scratches or
other damage.
3
Remove the speakers.(PDP-507XD/PDP-
507XA )
4
Referring to steps 2 and 3 in “Attaching
the Plasma Display” (Page 15.), remove
the installation screws (4 screws).
Note
Do not remove the screws (M8 x 16 mm: silver) by
procedure 2 in Page 14. The support columns might slip
out of place and fall over.
5
Holding the Plasma Display by its handles
and from the bottom, lift the display verti-
cally.
6
Place the Plasma Display slowly onto the
sheet laid out in step 2 with its screen
facing downwards.
Note
When reattaching the Plasma Display to the stand, be
certain that the left/right support columns are set at the
same angle.
Specifications
External dimensions 577 mm (W) x 305 mm (H) x 380 mm (D) (22-23/32 in. (W) x 12 in.(H) x 14-31/32 in. (D))
[When using the support columns S]
Weight 10.7 kg (23.6 lbs)
• The above specifications and exterior may be modified without prior notice to improve the product.
Caution
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
Use a screw that has a nominal
diameter of M4 and length from
20 mm to 30 mm (13/16 to 1-3/
16 inch) to fix the rotation to
the front. 20 mm to 30 mm
(13/16 to 1-3/16 inch)
M4
7 mm to 12 mm (5/16 to 1/2 inch)
Fixing the rotation to the front