Pioneer AVM-P8000R - Manual (Page 97)

Installation
96
Installation
Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all con-
nected up properly, and the unit and the system
work properly.
• Use only the parts included with the unit to
ensure proper installation. The use of unautho-
rized parts can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the dri-
ver’s way and cannot injure the passenger if
there is a sudden stop, like an emergency stop.
• When mounting this unit, make sure none of
the leads are trapped between this unit and the
surrounding metalwork or fittings.
• Do not mount this unit near the heater outlet,
where it would be affected by heat, or near the
doors, where rainwater might splash onto it.
• Before drilling any mounting holes always
check behind where you want to drill the holes.
Do not drill into the gas line, brake line, electri-
cal wiring or other important parts.
• If this unit is installed in the passenger com-
partment, anchor it securely so it does not
break free while the car is moving, and cause
injury or an accident.
• If this unit is installed under a front seat, make
sure it does not obstruct seat movement. Route
all leads and cords carefully around the sliding
mechanism so they do not get caught or
pinched in the mechanism and cause a short
circuit.
Installing the Unit
7 Mounting with Brackets
7 Mounting with Velcro Tape
Thoroughly wipe off the surface before affixing
the velcro tape.
Car mat or chassis
Velcro tape
Screw
(4
× 8 mm)
Car mat or chassis
Bracket
Tapping screw (4
× 12 mm)
Drill 2 to 2.5 mm diameter holes.