Pioneer DEH-P8100BT - Manual (Page 31)

Using a Bluetooth device to pair
1 Display the connection menu.
Refer to Introduction to connection operations
on the previous page.
2 Turn MULTI-CONTROL to select
Open device.
# If there is previous connection log in this unit,
you can select the Bluetooth device from
Paired device.
Refer to Pairing from this unit.
3 Push MULTI-CONTROL up or down to
select the special device.
# Bluetooth devices that are difficult to establish
connection is called special device. If your Blue-
tooth device is listed in the special device, select
the appropriate one.
4 Press MULTI-CONTROL to open the con-
nection.
Ready will be displayed.
This unit is now on standby for connection
from Bluetooth device.
# If five devices are already paired,
MEMORY FULL is displayed and it is not possible
to perform the pairing operation. In this case, de-
lete a paired device first. Refer to Deleting a paired
Bluetooth device on the next page.
# Push MULTI-CONTROL left or right to display
the device name, BD address and PIN code of
this unit.
5 Use your Bluetooth device to establish
connection.
Connection method is different depending on
the Bluetooth device. See the manual of your
Bluetooth device to establish connection.
While connecting,
Pairing flashes. If the con-
nection is established, Paired is displayed.
# If the connection fails, ERROR is displayed. In
this case, try again from the beginning.
# PIN code is set to 0000 as the default. You
can change this code in the initial setting. Refer
to Entering PIN code for Bluetooth wireless con-
nection on page 33.
Pairing from this unit
1 Display the connection menu.
Refer to Introduction to connection operations
on the previous page.
2 Use MULTI-CONTROL to select
Search device.
3 Push MULTI-CONTROL up or down to
select a device.
4 Press MULTI-CONTROL to start search-
ing.
While searching,
Searching flashes. When
available Bluetooth devices are found, device
name or BD address (if names cannot be ob-
tained) is displayed.
# To cancel searching, press MULTI-CONTROL
again.
# If five devices are already paired,
MEMORY FULL is displayed and it is not possible
to perform the pairing operation. In this case, de-
lete a paired device first. Refer to Deleting a paired
Bluetooth device on the next page.
# If no device can be found, NOT FOUND is dis-
played. In this case, check the status of Bluetooth
device and search again.
5 Push MULTI-CONTROL up or down to
select a device name you want to connect.
# If only one device was found, this step cannot
be performed.
# Push MULTI-CONTROL left or right to display
the device name and BD address.
6 Press MULTI-CONTROL to establish con-
nection.
While connecting,
Pairing flashes. If the con-
nection is established, Paired is displayed.
# If the connection fails, ERROR is displayed. In
this case, try again from the beginning.
# PIN code is set to 0000 as the default. You
can change this code in the initial setting. Refer
to Entering PIN code for Bluetooth wireless con-
nection on page 33.
Disconnecting a Bluetooth device
This function can be operated only when the
Bluetooth wireless connection is being estab-
lished.
1 Display the connection menu.
Refer to Introduction to connection operations
on the previous page.
2 Use MULTI-CONTROL to select
DisconnectDevice.
Using Bluetooth wireless technology
En
31
Section
08
Using
Bluetooth
wir
eless
technology