Pioneer DEH-P8100BT - Manual (Page 32)

3 Push MULTI-CONTROL up or down to
select a device.
# If only one device was found, this step cannot
be performed.
4 Press MULTI-CONTROL to disconnect
the Bluetooth wireless connection.
While disconnecting,
Disconnecting flashes.
If the Bluetooth wireless connection is termi-
nated,
Disconnected is displayed.
# If multiple Bluetooth devices have been con-
nected and you wish to disconnect them, press
MULTI-CONTROL and then select the device. In
this case, repeat operation from step 3.
Deleting a paired Bluetooth device
1 Display the connection menu.
Refer to Introduction to connection operations
on page 30.
2 Use MULTI-CONTROL to select
Delete device.
3 Push MULTI-CONTROL up or down to
select a device.
# If only one device was found, this step cannot
be performed.
# Push MULTI-CONTROL left to display the BD
address.
# If device name cannot be obtained, BD ad-
dress is displayed.
4 When the device name is being dis-
played, push MULTI-CONTROL right to dis-
play Delete YES.
Deleting device is now on standby.
# If you do not want to delete the device, push
MULTI-CONTROL left.
5 Press MULTI-CONTROL to delete the de-
vice.
While deleting,
Deleting flashes. After the de-
vice is deleted, Deleted is displayed.
# No data is displayed when no device is
paired.
Connecting a paired Bluetooth
device and selecting a service
Bluetooth service of the paired device can be
selected. You can choose a Bluetooth service
from PHONE service, AVRCP service or A2DP
service.
1 Display the connection menu.
Refer to Introduction to connection operations
on page 30.
2 Use MULTI-CONTROL to select
Paired device.
3 Push MULTI-CONTROL up or down to
select a device.
# If only one device was found, this step cannot
be performed.
# Push MULTI-CONTROL left or right to switch
the BD address and device name.
# If device name cannot be obtained, BD ad-
dress is displayed.
4 Press MULTI-CONTROL to display the
service select screen.
5 Push MULTI-CONTROL up or down to
select the service.
PHONE
—AVRCP—A2DP
# “
*
” is displayed on the connected service.
# Profile that is not compatible with the con-
nected device cannot be selected.
6 Press MULTI-CONTROL to start or stop
the selected service.
Connecting to a Bluetooth
device automatically
It is possible to set the automatic connection
between your Bluetooth device and this unit. If
this function is set to on, connection between
your Bluetooth device and this unit will take
place automatically as soon as the two devices
are less than a few meters apart.
! Initially, this function is set to on.
1 Display the connection menu.
Refer to Introduction to connection operations
on page 30.
2 Use MULTI-CONTROL to select
Auto connect.
3 Press MULTI-CONTROL to turn auto-
matic connection on.
If your Bluetooth device is ready for Bluetooth
wireless connection, connection to this unit is
automatically established.
Using Bluetooth wireless technology
En
32
Section
08