Pioneer AVX-P7300DVD - Manual (Page 24)

19
Operation of the Display
• Turn the vehicle’s engine OFF.
The display will be automatically closed by the automatic close/open mode. If the
display does not close automatically, press the OPEN/CLOSE button.
Note:
• When closing the display, check to make sure that it has closed completely. If the display has
stopped halfway, leaving it like this could result in damage to it.
• The automatic close/open mode will operate the display as follows.
* When the ignition switch is turned OFF while the display is deployed, the display will be
closed after approximately 6 seconds.
When the ignition switch is turned ON again (or turned to ACC), the display will be
deployed automatically.
* Removing the front panel will close the display. (Refer to page 12.)
• The automatic close/open mode can be switched ON/OFF. (Refer to page 56.)
• When the ignition switch is turned OFF after the display has been closed, turning the ignition
switch ON again (or turning it to ACC) will not deploy the display. In this case, press the
OPEN/CLOSE button to deploy the display.
Closing the Display