Pioneer AVIC-HD3-II - Manual (Page 14)

12
Chapter
2
How to Use
the N
aviga
tion System a
n
d Na
mes of t
h
e Pa
rt
s
Inserting/Ejecting a Disc
• When opening, closing and adjusting the
angle of the LCD panel, be careful not to
get your finger caught.
• Do not use with the LCD panel left open. If
LCD panel is left open, it may result in
injury in the event of an accident.
• Do not open and close the LCD panel with
hands by force. This may cause malfunc-
tion.
• Do not operate this navigation system
until the LCD panel completely opens or
closes. If this navigation system is oper-
ated while the LCD panel is opening or
closing, the LCD panel may stop at that
angle for safety.
• Do not place a glass or a can on this navi-
gation system when the LCD panel is
open. Doing so may break this navigation
system.
ò For details, refer to “Handling and Care of the
Disc” in the end of this manual and “Detail
Information for Playable Media” on the opera-
tion manual.
Inserting a disc
1
Press the OPEN CLOSE button.
The LCD panel opens, and the disc loading
slot appears.
r To close the LCD panel, press the OPEN
CLOSE button again.
When a disc is already set
The above screen is displayed.
Make sure the disc loading slot is empty before
inserting a disc into the slot.
2
Insert a disc into the disc loading slot.
When you insert a disc, the LCD panel closes
automatically, and then format reading will
start.
r When the ignition switch is turned off (ACC
OFF) with the LCD panel open, the LCD panel
remains open. Always make sure to close the
LCD panel before turning the ignition switch
off.
r Do not insert anything other than a disc into
the disc loading slot.
r The built-in DVD drive plays one, standard, 12-
cm or 8-cm (single) disc at a time. Do not use
an adapter when playing 8-cm discs.
r If you cannot insert a disc completely or if an
inserted disc is not recognised, check that the
label side of the disc is up. Press the EJECT
button to eject the disc, and check the disc for
damage before inserting the disc again.
r If the built-in DVD drive does not operate prop-
erly, an error message may be displayed.
ò Error messages Þ operation manual
EJECT button
Disc loading slot