Pioneer VSX-D710S - Manual (Page 6)

6
En
L R
L R
R L
S
FRONT L R FRONT L R SURROUND CENTER
COMPONENT
VIDEO
DIGITAL IN
PCM/2/DTS
DIGITAL
OUT
TO
MONTOR
TV
TO
MONTOR
TV VCR /
DVR
VIDEO
VIDEO
VCR /
DVR
TO MONITOR TV OUT
CONTROL
IN AUX
CD
IN
OUT
IN
IN OUT
OUT
CD - R
/ TAPE
/ MD
SURROUND
CENTER
SUB W.
SUB W.
PREOUT
IN
IN
IN
Y P B P R Y P B P R
S
IN
S
IN
S
OUT
S
OUT
IN
IN
IN
TV /
SAT
TV /
SAT
DVD/
LD
DVD
/ LD
FRONT
CENTER
PREOUT
(DVD) (CD) (CD-R)
COAX OPT OPT OPT
R
E
C
P
L
A
Y
A B
1 2
1
(TV/SAT) IN
(DVD/LD) IN
2
OUT
FM
UNBAL75
Ω
ANTENNA
AM
LOOP
DVD 5.1 CH INPUT
SPEAKERS
DIGITAL OUT
DIGITAL
OUT
COAX
DIGITAL
OUT
DIGITAL
IN
VSX-D710S
03
Digital Audio Cords/Optical
Cables
Commercially available digital audio coaxial cords
(standard video cords can also be used) or optical cables
(not supplied) are used to connect digital components to
this receiver.
When you use optical digital input or output terminals,
pull off the caps and insert the plugs. Be sure to insert
completely.
Digital audio cord
(or standard video cord) Optical cable
Connecting Your Equipment
Audio/Video Cords
Use audio/video cords (not supplied) to make analog
audio and video connections.
Connect red plugs to
R (right), white plugs to L (left),
and the yellow plugs to VIDEO .
Be sure to insert completely.
L
R
VIDEO
Connecting Digital Components
In order to use PCM/2 2 2 2 2 Digital/DTS soundtracks, you need to make digital audio connections.
You can do this by either coaxial or optical connections (you do not need to do both). The quality of these two types
of connections is the same but since some digital components only have one type of digital terminal, it is a matter of
matching like with like (for example, the coaxial out from the component to coaxial in on the receiver). The VSX-
D710S has a coaxial input and two optical inputs for a total of three digital inputs. The VSX-D810S has a coaxial
input and three optical inputs for a total of four digital inputs and the VSX-D850S has a coaxial input and four
optical inputs for a total of five digital inputs. Connect your digital components as shown below. There is one digital
out jack which is marked
DIGITAL OUT . If you connect this to the optical input on a digital recorder (currently these
include MD, DAT and CD-R) you can make direct digital recordings with this unit.
When connecting your equipment, always make sure the power is turned off and the power cord is disconnected
from the wall outlet.
DVD player
CD player
CD recorder
The arrows indicate the direction of the audio signal.
Before making or changing the connections, switch off the power and disconnect the power cord from the AC wall
outlet.