Pioneer DVR-530H-S - Manual (Page 34)

Getting started 04
34
En
Playing CDs and WMA/MP3 discs
The table below shows the basic playback controls for
audio CDs 1 , and WMA/MP3 files.
Playing Video CD/Super VCDs
The table below shows the basic playback controls for
Video CD/Super VCDs.
Some discs feature Playback Control (PBC for short)
menus. These discs show PBC in the display when you
load them and display a menu on-screen from where you
can select what to watch.
2
Press to start playback.
Press to stop playback.
Pauses playback, or restarts playback
when paused.
Press to start scanning. Press again to
increase the scanning speed. (There are
two scan speeds; the current scan speed
is shown on-screen.)
Press to skip to previous/next track (or
folder for WMA/MP3 disc). (During play-
back you can also use the front panel
+/–
buttons.)
During playback, enter a track number
then press
ENTER to skip directly to that
track.
Press
CLEAR to clear a number entry and
start again.
Note
1. If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with a digital connection. Noise
will be output through the analog outputs. Also make sure that STEREO is selected using the AUDIO button (see Switching audio channels
on page 69).
PLAY
STOP
PAUSE
REV SCAN FWD SCAN
PREV NEXT
CLEAR
CLEAR
ENTER
Press to start playback.
Video CD only: If RESUME is displayed on-
screen, playback starts from the place last
stopped.
Press to stop playback.
Video CD only: You can resume playback
from the same point by pressing PLAY .
(Press STOP again to cancel the resume
function.)
Pauses playback, or restarts playback
when paused.
Press to start scanning. Press repeatedly
to increase the scanning speed.
Press to skip to previous/next track.
When a PBC menu is displayed, press to
display the previous/next page. (During
playback you can also use the front panel
+/– buttons.)
During playback, enter a track number
then press
ENTER to skip directly to that
track.
Press
CLEAR to clear a number entry and
start again.
While a PBC menu screen is displayed,
use to select numbered menu items.
Video CD only: Each press skips backward/
forward progressively up to a maximum of
ten minutes forward or three minutes
back. Note that this function doesn’t work
when playing in PBC mode.
During playback, press to start slow-
motion playback. Press repeatedly to
change the playback speed (forward only).
While paused, press to advance a single
frame (forward only).
Press to display the disc menu of a Video
CD/Super VCD playing in PBC mode.
2. When playing in PBC mode, some playback features, such as search, repeat and program play are not available. You can play a PBC Video
CD/Super VCD in non-PBC mode by pressing to start playback instead of PLAY .
PLAY
STOP
PAUSE
REV SCAN FWD SCAN
PREV NEXT
CLEAR
CLEAR
ENTER
SKIP CM BACK
STEP/SLOW
RETURN
DVR-530H_EU.book 34 ページ ２００５年２月１４日 月曜日 午後２時２０分