Pioneer DVR-230-S - Manual (Page 15)

Connecting up 02
15
En
Connecting an external decoder box (2)
If you only have a decoder, connect it to this recorder and your TV as shown on this page.
Using the setup on this page you can:
• Record scrambled channels received using the recorder’s built-in TV tuner.
Important
• Do not connect this recorder ‘through’ your VCR, satellite receiver or cable box. Always connect each component
directly to your TV or AV amplifier/receiver.
1 Connect RF antenna cables as shown.
This enables you to watch and record TV channels.
2 Use a SCART cable (not supplied) to connect the
AV1•RGB-TV AV connector to a SCART AV connector
on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect the AV2
(INPUT 1/DECODER) AV connector to a SCART AV
connector on your decoder box.
This enables you to record scrambled TV channels.
Note
• In order to use this setup, you will need to make the
following settings from the Initial Setup menu:
– Set the
AV2/L1 In setting to Decoder from the
Initial Setup menu (see AV2/L1 In on page 54).
– From the Manual CH Setting screen, set the
Decoder setting for the scrambled channels to On
(see Manual CH Setup on page 50).
TV
Decoder Antenna/cable TV
wall outlet
IN
OUT
R Y P B P R L AUDIO VIDEO S-VIDEO OUTPUT DIGITAL OUT COMPONENT VIDEO OUT
AV 1 ･RGB - TV AV 2 (INPUT 1 DECODER)
ANTENNA
SCART AV
CONNECTOR
SCART AV
CONNECTOR
ANTENNA
IN
1
2
3
1
DVR-230_UK.book Page 15 Friday, July 1, 2005 11:52 AM