Pioneer AVIC-X1BT - Manual (Page 16)

14
Chapter
1
How to U
se
the N
aviga
tion System a
n
d Na
mes of t
h
e Pa
rt
s
❒ Do not insert anything other than a disc into
the disc loading slot.
➲ “Playable discs” ➞ Page 5
❒ If you cannot insert a disc completely or if the
disc is not recognised after you insert a disc,
check that the label side of the disc is up.
Press the EJECT button to eject the disc, and
check the disc for damage before inserting
the disc again.
❒ If the DVD drive does not operate properly, an
error message such as ERROR-11 may be dis-
played.
➲ Error messages ➞ Operation Manual
Adjusting the Volume
• Use the VOLUME/ATT button to adjust
the audio sound level.
Rotate the VOLUME/ATT button to increase
or decrease the volume.
❒ To adjust the navigation volume, go to the
navigation menu.
➲ Navigation volume adjustment ➞ Opera-
tion Manual
Turning the Source Off
• Press the SRC button and hold until the
source turns off.
❒ This product also can be switched off by
turning the ACC (ignition) OFF or detach-
ing the front panel.
Using the REAR/GUIDE Button
You can output the sound and video of the disc in
the built-in DVD drive to the rear display regard-
less of whether DVD drive is selected as the
source (REAR ON mode).
• When you have turned the REAR ON mode
on by pressing the REAR/GUIDE button,
you cannot turn it off even if you press the
SRC button and hold. In this case, press
the REAR/GUIDE button to turn the REAR
ON mode off.
• Press the REAR/GUIDE button to turn the
REAR ON mode on.
The sound and video are output to the rear
display and the illumination colour of the
REAR/GUIDE button changes to different
colour.
❒ To turn the REAR ON mode off, press the
REAR/GUIDE button again.
❒ When a CD or CD-ROM is inserted, sound
only is output to the rear display.
➲ Selecting the video of rear display ➞ Opera-
tion Manual
Opening and Closing the LCD
Panel
• Do not close the LCD panel with hands by
force. This may cause malfunction.
• Keep hands and fingers clear of the dis-
play unit when opening, closing, or adjust-
ing the LCD panel. Be especially cautious
of children’s hands and fingers.
The LCD panel will open or close automatically by
turning the ignition switch on or off. You can turn
off the automatic open/close function.
➲ Setting the automatic open/close function ➞
Operation Manual
• The automatic open/close function will operate
the display as follows:
— When the ignition switch is turned OFF
while the LCD panel is open, the LCD panel
will close after six seconds.
— When the ignition switch is turned ON
again (or turned to ACC), the LCD panel will
open automatically.
— Removing or attaching the front panel will
automatically close or open the LCD panel.
➲ Removing the front panel ➞ Page 15
• When the ignition switch is turned OFF after
the LCD panel has been closed, turning the
ignition switch ON again (or turning it to ACC)
will not open the LCD panel. In this case, press
the OPEN/CLOSE button to open the LCD
panel.
• When closing the LCD panel, check to make
sure that it has closed completely. If the LCD