Pioneer AVIC-X1BT - Manual (Page 19)

17
App
endi
x
Appendix
Troubleshooting
➲ Troubleshooting problems other than those described below ➞ Appendix of the Operation Manual
Symptom Cause Action (See)
No picture. The handbrake cord is not connected. Connect the handbrake cord, and apply the
handbrake.
The handbrake is not applied. Connect the handbrake cord, and apply the
handbrake.
The picture is
stretched, the aspect is
incorrect.
The aspect setting is incorrect for the dis-
play.
Select the appropriate setting for your dis-
play. (➞ “Changing the Wide Screen Mode”
and “Operating the Picture Adjustment” in
the Operation Mannual.)
Rear display picture
disappears.
The source disc being played back with the
navigation system has been ejected.
Before ejecting the disc, switch the source.
This problem may occur when certain con-
nection methods are used.
The REAR/GUIDE button was pressed and
REAR ON mode switched off.
Press the REAR/GUIDE button to turn
REAR ON mode on.
There was a problem with the rear display
or a faulty wiring connection, for example.
Check the rear display and its connection.
Rear View is selected on the screen. Select view mode other than Rear View.
When the gear stick is in [R], the screen dis-
plays rear view camera images. (When
“NAVI” is selected in REAR DISP menu.)
Move the gear stick to a position other than
[R]. (Select “SOURCE” in REAR DISP
menu.)
A source without video is selected. Switch to a source with a video.
Operating PICTURE ADJUSTMENT. There is no picture on the rear display while
PICTURE ADJUSTMENT is carried out.
Nothing is displayed
and the touch panel
keys cannot be used.
The setting for the rear view camera is
incorrect.
The gear stick was placed in [R] when the
rear view camera was not connected.
Connect a rear view camera correctly.
Press the NAVI/AV button to return to the
source display and then select the correct
setting for CAMERA.
➲ About CAMERA setting ➞ Operation
Manual
Volume of beeps and
navigation guidance
cannot be adjusted.
You cannot adjust these parameters with
the VOLUME/ATT button.
• Turn the volume up or down with
“Volume” in the Setting menu.
• Press the REAR/GUIDE button ond turn
the volume up or down.
Playback is not possi-
ble.
The disc is dirty. Clean disc.
The loaded disc is a type your navigation
system cannot play.
Check what type the disc is. (➞ Page 18)
Non compatible video system disc is
loaded.
Change to a disc compatible to your video
system. (➞ Page 18)
The loaded disc has a different region
number from the navigation system.
Replace the disc with one featuring the
same region number as the navigation sys-
tem. (➞ Page 6)
LCD Panel knocks
against your vehicle’s
console or dashboard.
Incorrect angle setting. Press the ANGLE (+/–) button to adjust the
LCD angle. Forcibly adjusting the LCD panel
by hand may damage it.
Video image appears
grainy.
This happens when videos are viewed in
CINEMA or ZOOM mode.
Select a different mode to view videos.