Pioneer AVH-P7900DVD - Manual (Page 91)

When tweeter is selected in the network
mode
Parameter What it does
FREQUENCY
Selects cut-off frequencies in the fol-
lowing order:
1.25k
—1.6k—2k—2.5k—3.15k—
4k —5k—6.3k—8k—10k—12.5k
(Hz)
SLOPE
Selects slopes in the following order:
–12— –6 (dB/oct.)
PHASE
Switches the phase between NOR-
MAL and REVERSE.
When front speaker HPF is selected in the
network mode
Parameter What it does
FREQUENCY
Selects cut-off frequencies in the fol-
lowing order:
50
—63—80—100—125—160—
200 (Hz)
SLOPE
Selects slopes in the following order:
–18— –12— –6 (dB/oct.)
To switch the filter of the front speaker between LPF and
HPF, touch
HIGH PASS or LOW PASS.
When front speaker LPF is selected in the
network mode
Parameter What it does
FREQUENCY
Selects cut-off frequencies in the fol-
lowing order:
1.25k
—1.6k—2k—2.5k—3.15k—
4k —5k—6.3k—8k—10k—12.5k
(Hz)
SLOPE
Selects slopes in the following order:
–12— –6—0 (pass) (dB/oct.)
# You can mute the selected speaker unit by
touching
MUTE OFF. To cancel muting, touch
MUTE ON.
Notes
! Selecting cut-off frequencies sets cut-off fre-
quencies of the subwoofer
’s L.P.F. (low-pass
filter) and that of the SMALL speaker H.P.F.
(high-pass filter). The cut-off frequency setting
has no effect if the subwoofer is set to
OFF
and other speakers are set to LARGE or OFF.
! If trying to boost the bass output of the sub-
woofer doesn
’t do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer
’s output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
! You can store the adjusted setting in memory
by using MEMORY. For details concerning op-
eration, refer to Storing the adjusted audio set-
tings in memory on page 94.
Using the time alignment
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
Recalling time alignment settings
% Touch TIME ALIGNMENT on the sound
setting menu to select the time alignment.
Touch
TIME ALIGNMENT repeatedly to switch
between the following time alignment set-
tings:
INITIAL
—AUTO—CUSTOM1—CUSTOM2—
CUSTOM3
—LAST MEMORY—OFF
# You can select LAST MEMORY only when the
adjusted time alignment setting is not memorized
in this unit.
# You cannot select AUTO when NETWORK
has been selected. (Refer to Switching the DSP
setting mode on page 108.)
# When STANDARD has been selected, you
cannot select
AUTO if auto TA and EQ has not
been carried out.
Audio Adjustments
En
91
Section
17
Audio
Adjustments