Pioneer AVH-P7900DVD - Manual (Page 93)

2 Touch ADJ. next to SPEAKER LEVEL on
the sound setting menu and then touch
TEST TONE.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
Front left speaker
—Front center speaker—
Front right speaker
—Rear right speaker—Rear
center speaker
—Rear left speaker—Subwoo-
fer
Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the
test tone.
# Using TEST TONE, the tweeters and the front
speakers are adjusted same time. To adjust them
separately, please refer to Adjusting the speaker
output levels finely on this page.
# The settings do not appear for speakers
whose size is set
OFF. (Refer to Customizing the
speaker setting on page 89.)
3 Touch or to adjust the speaker out-
put level.
Each time you touch
or it increases or de-
creases the speaker output level.
–24dB to
+10dB is displayed as the level is increased or
decreased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Touch STOP to stop the test tone out-
put.
Notes
! You can mute the selected speaker units by
touching the speaker icon (e.g., ) and then
MUTE. When muted, MUTE is displayed in-
stead of speaker output level. To cancel mut-
ing, touch the speaker icon and then
MUTE.
! If needed, select speakers and adjust their ‘ab-
solute
’ output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
! You can store the adjusted setting in memory
by using MEMORY. For details concerning op-
eration, refer to Storing the adjusted audio set-
tings in memory on the next page.
! The adjusted speaker output level cannot be
stored by each listening position. This means,
memorizing a speaker output level for custom
setting overwrites the levels of all listening po-
sitions.
Adjusting the speaker output
levels finely
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Recall the speaker output level settings
you want to adjust.
Refer to Recalling the speaker output level set-
tings on the previous page.
2 Touch ADJ. next to SPEAKER LEVEL.
3 Touch or to adjust the speaker out-
put level.
Each time you touch
or it increases or de-
creases the speaker output level.
–24dB to
+10dB is displayed as the level is increased or
decreased.
# You cannot select speakers whose size is set
at
OFF. (Refer to Customizing the speaker setting
on page 89.)
Notes
! You can store the adjusted setting in memory
by using MEMORY. For details concerning op-
eration, refer to Storing the adjusted audio set-
tings in memory on the next page.
Audio Adjustments
En
93
Section
17
Audio
Adjustments