Pioneer PDK-WM03 - Manual (Page 15)

E-4
1 Line up the screw holes (ø9, indicated on the diagram) at
the tops and bottoms of the display fittings (one each for
left and right sides) with the screw holes (M8) in the rear
panel of the plasma display, and fasten the display fittings
using 2 of the included M8 screws for each fitting.
There are two display fittings, one for the right side, the other for the left. Mount the fittings so that their eye bolts
are at the inner side.
Reference: (PDP-614MX only)
When using the PDK-TS06 optional stand , the display
fittings can be attached with the plasma display
mounted on the stand.
Remove the four M6 screws fastening the display
to the stand before attaching the display fittings.
When lifting the plasma display, do not allow the
stand to be lifted together with the display. If the
stand were to come off, it could cause injury or
damage.
1. Attaching the Display Fittings to the Plasma Display
Horizontal Installation
Screw the wall mounting unit to the wall using commercially available anchors or the 6 M8 screws.
2.Attaching the Wall Mounting Unit to the Wall
Gypsum board
Plywood
Concrete
Block
ALC
Mortar
Brick
Wooden posts
* The extraction strength should be 500 kg or greater per position.
Wall Material Anchor
* Do not mount on plaster or plywood boards.
Be sure to fasten into a beam.
All anchors (850) or bolt plugs (300)
Coach screws (ø8 x 50)
Tie-Lock anchors (No. 25)
NOTE: Make sure that the anchors or
screws are fastened into sections of the wall
at which there are beams. (Use anchors or
screws that are suited for use on the type
of wall on which the unit is being mounted.)
For details, see the following Table of Wall
Material vs. Anchors and Screws.
■ Table of Wall Material vs. Anchors and Screws
φ9
φ9
アイボルト
For the Left
For the Right
Eye bolt
850
950
400
591
494.5
Center