Pioneer PDP-S12-LR - Manual (Page 3)

3
English
English
INSTALLATION ON THE PLASMA
DISPLAY
(WHEN INSTALLING THE SPEAKERS ON THE RIGHT AND
LEFT SIDES OF THE DISPLAY)
1 Attach the mounting fittings to the
speakers.
The illustration below shows the right speaker.
1 Align the convex portion of the holder for installing the
speakers on the right and left sides with the concave
portion of the speakers.
2 Fix the two points with screws.
3 Attach holders to the top and bottom of one speaker.
4 Similarly, attach two holders to
the top and bottom of the other
speaker.
2 Attach the speakers to the display.
The illustration below shows how to attach of the right speaker.
1 Fix the upper screw temporarily in
advance to hang the speaker on
the display (In this case, leave a
space of about 5 mm between the
head of the screw and the display).
2 Hang the speaker on the upper
screw.
3 Fix the lower screw temporarily.
4 Adjust the position so that the speaker is parallel to the
display and then fix the upper and lower screws firmly.
Perform installation according to the following steps 1 to 2.
INSTALLATION ON THE PLASMA
DISPLAY
(WHEN INSTALLING THE SPEAKERS AT THE BOTTOM
OF THE DISPLAY)
1 Attach the mounting fittings to the
display.
1 Push rivets into each outside hole A of brackets (on the
right and left sides) for installing the speakers at the bottom.
2 Fix each outside hole B of brackets (on the right and left sides),
for installing the speakers at the bottom, with screws.
3 Insert the screws into the two outside holes of bracket
(at the center), for installing the speakers at the bottom,
and tighten them.
4 Align the bosses of the spacer with the holes of the stand
and insert them.
2 3
5mm
The display
1
2 4
3
Perform installation according to the following steps 1 to 2.
5 Attach the left speaker following the
same procedure as described above.
1
1
2 2
B
B
A
A
PDPS12LR.01-06/En 03.6.10, 1:50 PM 3