Pioneer PDP-S12-LR - Manual (Page 6)

English
6
SPECIFICATIONS
NOTE:
Specifications and design subject to possible modification
without notice, due to improvements.
Cabinet : Bass-reflex type
Used speakers (two-way system) :
Woofer (for low tones) ............................ Oval cone type
Tweeter (for high tones) .................... 2.5 cm dome type
Nominal impedance ..................................................... 8
Ω
Frequency Range ..................................... 50 to 20,000 Hz
Sensitivity ................................ 82 dB/W (at 1 m distance)
Permissible input :
Max. input ............................................................... 13 W
Rated input .............................................................. 4 W
Crossover frequency ................................................ 3 kHz
External Dimensions .... 107.5 (W) x 634 (H) x 65 (D) mm
Weight ..................................................................... 1.4 kg
Accessory parts (for 2 speakers)
.............................................................. Speaker cable x 2
............ Bracket for installing the speakers at the bottom
(for right and left side) x 2
............ Bracket for installing the speakers at the bottom
(for center) x 1
........................................................ Screw (M5 x 10) x 12
.... Holder for installing the speakers on the right and left x 4
............................................................................. Rivet x 2
................................................ Operating Instructions x 1
Published by Pioneer Corporation.
Copyright © 2003 Pioneer Corporation.
All rights reserved.
CABINET MAINTENANCE
÷ Use a polishing cloth or dry cloth to wipe off dust and
dirt.
÷ When the cabinet is very dirty, wipe with a soft cloth
moistened with water-diluted cleanser; then wipe again
with a dry cloth. Do not use furniture wax or cleaners.
They may damage the surface of the cabinet.
÷ Never use thinner, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will cor-
rode the surfaces.
÷ When a chemical cloth is used, read the cautions for the
chemical cloth carefully.
PDPS12LR.01-06/En 2003.6.13, 11:46 AM 6