Pioneer X-SMC11DAB-S - Manual (Page 20)

USB playback 07
20
En
Chapter 7:
USB playback
Playing USB storage devices
It is possible to listen to two-channel audio using the USB
interface on the side of this unit.
• Pioneer does not guarantee that any file recorded on a
USB storage device will play or that power will be
supplied to a USB storage device. Also note that Pioneer
will accept no responsibility whatsoever for loss of files
on USB storage devices caused by connection to this
unit.
1 Press USB on the remote control or INPUT
repeatedly on the main unit to select USB/IPOD
input.
“USB/IPOD” is shown on the main display.
2 Connect the USB storage device.
The number of folders or files stored on the connected USB
storage device appear on the main display automatically.
• This unit does not support a USB hub.
• If an iPod/iPhone/iPad is connected to the unit, the unit
will automatically begin charging it.
3 When the recognition is completed, press
 to start playback.
• When changing to a different input source, stop the USB
memory playback first, before changing.
4 Disconnect USB storage device from the USB
terminal.
Turn the power off before removing the USB storage device.
Note
• USB flash drive that supports USB 2.0 can be used.
• This unit may not recognize a USB storage device, play
files or supply power to a USB storage device. For
details, see When a USB storage device is connected on
page 27.
• When a USB storage device is not playing and no
operations have been performed for more than 20
minutes, the unit will automatically power off.
• Auto power off can be switched to ON/OFF (page 31).
Repeat play
Repeat play can play one track, all tracks or a programmed
sequence continuously.
To repeat one track:
Press REPEAT repeatedly until “RPT ONE” appears. Press
ENTER
.
To repeat all tracks:
Press REPEAT repeatedly until “RPT ALL” appears. Press
ENTER
.
To repeat desired tracks:
Perform steps 1 to 5 in “Programmed play (CD or MP3/WMA)”
section on next page and then press REPEAT repeatedly until
“RPT ALL” appears. Press ENTER.
To cancel repeat play:
Press REPEAT repeatedly until “RPT OFF” appears. Press
ENTER
.
Note
• After performing repeat play, be sure to press .
Otherwise, the file of USB storage device will play
continuously.
• During repeat play, random play is not possible.
• When random play is set up during repeat play, the
repeat play will be canceled.
Random play
The file of USB storage device can be played in random order
automatically.
To random play all tracks:
Press RANDOM repeatedly until “RDM ON” appears. Press
ENTER
.
To cancel random play:
Press RANDOM repeatedly until “RDM OFF” appears. Press
ENTER
.
PHONES
AUDIO IN
ANTENNA
DC IN
18 V
5 V
2.1 A
USB storage device
(commercially
available)
X-SMC11DAB-S_VXE8_En.book 20 ページ ２０１３年８月６日 火曜日 午前９時２５分