Pioneer F-F6-J - Manual (Page 13)

Listening to FM/AM 04
13
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 4:
Listening to FM/AM
Auto preset memory
1 Make sure that the unit is in standby
mode, and then press the  button to turn on
the power.
2 Watching the display, press the BAND
button to select the desired band (AM or FM).
3 Press the A.PRESET/A.TUNE button.
4 Press the ENTER button.
The unit automatically begins searching for the
broadcast stations.
• When the first broadcast station is found,
that station is stored in the preset memory
at channel A1.
Subsequent stations are automatically
stored in order at preset channels A1 to
A10, B1 to B10, C1 to C10, D1 to D10,
E1 to E10, F1 to F10, G1 to G10, H1 to H10,
I1 to I10 and J1 to J10 for a maximum of 100
stations.
• Channel A1 is tuned in after the auto preset
memory operation is completed.
• If a station cannot be preset automatically
due to poor reception, use the “Manual
tuning” operation to tune in the station,
then preset it using the manual “Preset
stations” operation.
• To interrupt this function, press the 
button.
• This function does not operate with the
AUTO TUNE button on the front panel of
the unit.
• Perform this operation from the remote
control unit.
DEFAULT VALUE
TUNER
DIMMER
A.PRESET/A.TUNE
TUNE+
TUNE-
ST+ ST-
MEMORY
ENTER
A/B/C
D/E/F
MENU
BAND
MPX
MUTE
G/H
I/J
1 2 3
4 5 6
7 8
10
9
VOLUME
DISP
AMP CONTROL
Auto tuner presets
A1 to A10 87.5 MHz/88.0 MHz/90.0 MHz/
92.0 MHz/94.0 MHz/96.0 MHz/
98.0 MHz/100.0 MHz/102.0 MHz/
104.0 MHz
B1 to B10 106.0 MHz/108.0 MHz/98.0 MHz/
98.0 MHz/98.0 MHz/98.0 MHz/
98.0 MHz/98.0 MHz/98.0 MHz/
98.0 MHz
C1 to C10 98.0 MHz
D1 to D10 98.0 MHz
E1 to E10 98.0 MHz
F1 to F10 531 kHz/531 kHz/603 kHz/801 kHz/
999 kHz/1197 kHz/1395 kHz/
1602 kHz/1602 kHz/999 kHz
G1 to G10 999 kHz
H1 to H10 999 kHz
I1 to I10 999 kHz
J1 to J10 999 kHz
01_F-F6_EN.book 13 ページ ２００７年９月３日 月曜日 午後１時５８分