Pioneer F-F6-J - Manual (Page 15)

Listening to FM/AM 04
15
En
English
Français
Deutsch
Nederlands
Italiano
Español
Improving FM stereo sound
If the TUNED or STEREO indicator fails to light
when tuning into an FM station due to a weak
reception signal, press the
MPX button to
switch the tuner into mono reception mode. 1
This should improve the sound quality and
allow you to enjoy the broadcast.
Recalling preset stations
For instructions on presetting stations, see the
section “Preset stations” (page 16).
1 Connect the antenna and confirm that
reception is possible.
2 Press the POWER or  button to turn on
the power.
3 Press the MENU button to select menu.
4 Either turn the TUNING/PRESET dial or
press the ST + or ST – button to select the
search mode.
5 Either turn the TUNING/PRESET dial or
press the ST + or ST – button to select
“Preset”.
6 Press the TUNING/PRESET dial or ENTER
button to set the preset mode.
7 Watching the display, either turn the
TUNING/PRESET dial, or press the ST + or
ST – button to select the desired preset
channel.
7-1 Press one of the preset channel range (A
to J) buttons to select the desired memory
block (A to J).
7-2 Press one of the station call (1 to 10)
buttons to select the desired preset channel
(1 to 10).
• Steps 1 to 5 can be skipped when using the
ST +/–, preset channel range (A to J) and
station call (
1 to 10) buttons.
The preset mode is set when any of these
buttons is pressed, regardless of the menu
setting at that time.
Note
1 The STEREO indicator will light blue when the MPX button is pressed.
DIMMER
A.PRESET/A.TUNE
TUNE+
TUNE-
ST+ ST-
MEMORY
ENTER
A/B/C
D/E/F
MENU
BAND
MPX
G/H
I/J
1 2 3
4 4 5 6
7 8
10
9
DISP
ON OFF
POWER
STANDBY
F6
SECONDARY RDS TUNED STEREO
BAND
DISPLAY AUTO TUNE
MENU TUNING/PRESET
01_F-F6_EN.book 15 ページ ２００７年９月３日 月曜日 午後１時５８分