Pioneer PD-D6MK2-K - Manual (Page 12)

Getting started 04
12
En
Chapter 4
Getting started
Switching on
After making sure that everything is connected
properly and that the player is plugged in, push
the
POWER button into the ON position to
switch the player on.
• Press CD PLAYER  on the remote to
switch the unit into standby.
Playing discs
The basic playback controls for playing CDs,
SACDs, and MP3/WMA discs are covered
here. Further functions are detailed in Other
playback features on page 13.
1 If the player isn’t already on, press
POWER to switch it on.
2 Press  (OPEN/CLOSE) to open the disc
tray.
3 Load a disc.
Load a disc with the label side facing up, using
the disc tray guide to align the disc. Once
properly seated, press
 to close the disc tray.
4 Press  (play) to start playback.
Basic playback controls
The table below shows the basic controls for
playing discs.
ON OFF
POWER
STANDBY
PURE AUDIO
POWER OFF ON
CD PLAYER OPEN/CLOSE
TIME DIMMER
SACD/CD PURE AUDIO
CLEAR ENTER
LEGATO
LINK
1 2 3
4 5 6
7 8
0
9
CD PLAYER OPEN/CLOSE
PURE AUDIO
1 2 3
4 5 6
7 8
0
9
ENTER
Button What it does
 Starts playback.
 Pauses a disc that’s playing, or
restarts a paused disc.
/
(front panel
only)
Starts playback/stops a disc that’s
playing.
• While depressing
/, press 
(front panel only). Counting from the
first track on the disc, playback will
begin from the track number
corresponding to the number of
times
 is pressed.
 Stops playback.
 Press to start fast reverse scanning.
Press
 (play) to resume normal
playback.
 Press to start fast forward scanning.
Press
 (play) to resume normal
playback.
PD-D6MK2_en_SYXJ5.book 12 ページ ２００９年４月１５日 水曜日 午後５時２３分