Pioneer AVH-X8600BT - Manual (Page 3)

< CRD4782-A >3
English
3
Engb
Connecting the power cord
Aerial jack
Vehicle Bus adapter input
Please refer to the instruction manual for the Vehicle Bus adapter (sold separately).
Power supply
Power cord
Vehicle Bus onversion cable 15.8 cm
Notes:
· Change the initial setting of this unit. The subwoofer output of this unit
is monaural.
· When using a subwoofer of 70 W (2 Ω) , be sure to connect with Violet
and Violet/black leads of this unit. Do not connect anything to Green
and Green/black leads.
Connection method
1. Clamp the lead. 2. Clamp firmly with
needle-nosed pliers.
Note:
· The position of the hand brake switch depends on the vehicle model. For details, consult
the vehicle Owner’s Manual or dealer.
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on
that equipment. If not, keep the Audio Mute lead free of any connections.
Light green (PARKING BRAKE)
Used to detect the ON/OFF status of the handbrake. This lead must
be connected to the power supply side of the handbrake switch.
Blue/white
Connect to system control terminal of the
power amp (max. 300 mA 12 V DC).
Blue/white (6*)
Connect to auto-aerial relay control terminal
(max. 300 mA 12 V DC).
The pin position of the ISO
connector will differ depending on
the type of vehicle. Connect 5* and
6* when Pin 5 is an aerial control
type. In another type of vehicle,
never connect 5* and 6*.
Blue/white (5*)
Earth side
Power supply side
Handbrake
switch
ISO connector
Note:
In some vehicles, the ISO connector may be divided into
two. In this case, be sure to connect to both connectors.
Note:
Depending on the kind of vehicle,
the function of 2* and 4* may be
different. In this case, be sure to
connect 1* to 4* and 3* to 2*.
1*
3*
2*
4*
Yellow (2*)
Back-up
(or accessory) Yellow (1*)
Connect to the constant 12 V
supply terminal.
Connect leads of the same
colour to each other.
Red (4*)
Accessory
(or back-up) Red (3*)
Connect to terminal controlled by
ignition switch (12 V DC).
Black (earth)
To vehicle (metal) body.
This product
Microphone
Orange/white
To lighting switch terminal.
Violet/white
Of the two lead wires connected to the back lamp, connect the one in which the
voltage changes when the gear stick is in the REVERSE (R) position. This connection
enables the unit to sense whether the car is moving forwards or backwards.
4 m
Please contact your dealer to
inquire about the connectable
navigation unit.
Wired remote input
Hard-wired remote control adapter can be connected (sold separately).
Speaker leads
White:
Front left
White/black: Front left
Grey: Front right
Grey/black: Front right
Green: Rear left  or subwoofer
Green/black: Rear left  or subwoofer
Violet: Rear right  or subwoofer
Violet/black: Rear right  or subwoofer
Pioneer
navigation
system
RGB cable(Supplied with Navigation system)
Fuse (10 A)