Bernina Baby Accessories - Manual (Page 2)

©2011 BERNINA of America, Inc. jpl Page 2 of 10
Stitch the Embroidery & Appliqués
Note: You may stitch the designs of your choice
or refer to the section “Planning Circles” for the
specific designs, design combinations, and fabric
colors used for each block, as well as how to
combine designs in BERNINA Embroidery Soft-
ware v6.
 Adhere two hoop-sized rectangles of OESD
Ultra Clean & Tear stabilizer together with 505
Temporary Adhesive Spray.
 Spray the top of the layered stabilizer with addi-
tional 505 and adhere the stabilizer to the wrong
side of one of the fabric pieces for embroidery.
Refer to the “Planning Circles” section for color
and size of fabric for the individual designs.

Attach the hoop to the embroidery machine and
embroider the first design.
Note: Some of the designs from the “Snuggle Up”
collection are appliqué designs. To stitch these
designs, follow the instructions in the Embroi-
dered Appliqué sidebar.

After the design has finished stitching, remove
the excess stabilizer from the back of the piece.

Place the embroidered fabric right side down on
a fluffy towel and press. Allow the item to cool
before moving it.

Repeat for each of the twelve designs.
Cut and Bind the Circles
Refer to the section “Planning Circles” for sugges-
tions on the particular binding fabric to be used
with each design.

Cut each of the embroidered designs into a
9” circle, keeping the designs centered. Fuse
a 9” circle of OESD Fuse & Fleece to the wrong
side of each embroidered circle.
TIP: You may find it easier to cut the Fuse & Fix
into a 10” squares and then center and fuse it to
the back of the embroidered fabric pieces. The
circles can then be cut through both fabric and
batting, which will guarantee that the cut edges
will match.
Embroidered Appliqué
 Stitch the placement line (color 1). Remove the
hoop from the machine. DO NOT remove the
fabric from the hoop.
 Print the appliqué shape pattern from the PDF
provided with the design collection. Roughly cut
around the pattern piece.
 Cut a rectangle of Appliqué Fuse & Fix slightly
larger than the pattern piece. Fuse the shiny
side (the non-paper side) to the wrong side of
the appliqué fabric.
 Spray the wrong side of the paper pattern
lightly with 505 Temporary Adhesive Spray and
position the sprayed side of the paper on the
right side of the appliqué fabric.
 Carefully cut out
the fabric with a
very sharp pair of
scissors. Remove
the paper pattern.
 Turn the appliqué
piece over and
score an “X”
through the paper
only. Gently re-
move the paper to
reveal the adhesive
surface.
 Position the
adhesive side of
the appliqué piece
inside the stitched
placement lines.
 Attach the hoop to the machine and finish
stitching the design.
 Repeat the process if there is more than one
appliqué piece in the design.