Bernina Baby Accessories - Manual (Page 7)

©2011 BERNINA of America, Inc. jpl Page 7 of 10
 Click on the Write to Machine icon and send the
design to a USB stick or your embroidery sys-
tem.
Monkeys Chasing Tails
(14” x 20” moss yellow fabric; bind with bias color 2)

Open design
BC01402 — the
small monkey.
 Right click on the
Show Hoops
icon.
Select Jumbo Hoop
#26 and place a check in the box next to Display
Hoops
. Click OK.
Note: If you do not have an 830 with the Jumbo
Hoop, continue to work in the Large Oval Hoop.
The design will be too large to stitch in one hoop-
ing, so you will need to reposition the designs to
fit, or use the Multi-Hooping feature of BERNINA
Embroidery Software 6.
 Click View > Zoom Out 2x.
 Select the monkey and click the Wreath icon.
Change the number in the box to 5.
 Move the mouse without clicking until the tail of
one monkey is near the cheek of the following
monkey. Click the mouse when you are satisfied
with the placement.
 Press “C” on the computer keyboard to view the
design in the center of the workspace.
 Save the design as Monkeys Chasing
Tails.ART.
 Click on the Write to Machine icon and send
the design to a USB stick or your embroidery
system.
Monkey Sitting on Turtle
(10” x 14” green fabric; bind with bias color 1)
 Open design
BC01414 — the
monkey and turtle
group.
 Right click on the
Show Hoops
icon.
Select the artista
255 x 145 Oval Hoop
from the drop down
menu and place a
check in the box next to Display Hoops. Click OK.
 Select File > Insert Design and select design
BC01419 — the plant. Move it to the right of the
monkey and turtle design. Visually align the lower
edges of the two designs.
 Select File > Insert Design and select design
BC01410 — the sun. Move it between, and
slightly higher than, the monkey and the plant.
Click the Show All icon to see the entire design.

Save
the design as Monkey Sitting on Turtle
Grouping.ART.
 Click on the Write to Machine icon and send the
design to a USB stick or your embroidery system.
Stork & Turtle
(10” x 14” ivory fabric; bind with bias color 2)
 Open design
BC01427 — the
turtle.
 Select File > Insert
Design
and select
design BC01424 —
the stork. Move it to
place its feet on the
turtle’s back.
 Click the Remove Overlaps icon.

Save
the design as Stork and Turtle.ART.
Planning the Circles in BERNINA Embroidery Software 6
Visit www.berninausa.com
for additional BERNINA projects,
product information, and promotions!