Beltronics Vector 955 - Manual (Page 16)

14
City Mode Sensitivity
City STD (Standard)
In this setting, when you put your V955 in
the City mode, X-band sensitivity is
significantly reduced, to reduce annoyance
from X-band intrusion alarms and motion
sensors. (factory default)
City LoX (Low X band sensitivity)
In this setting, when you put your V955 in
the City mode, X-band sensitivity is reduced
more than the standard setting. This will
reduce X-band alarms from other sources
even further, but also significantly reduces
range to X-band traffic radar.
City NoX (No X-band sensitivity)
In this setting, when you put your V955 in
the City mode, V955 will not respond to
any X-band signals.
NOTE: These settings only apply
when the V955 is operated in City
mode. X-band sensitivity is not
affected when used in “AutoScan”
or “Highway” modes.
WARNING: Only choose this setting
if you are absolutely certain that
there are no X-band traffic radar
units where you drive.
Bands
BandsDFT
In this setting, all radar and laser frequencies
are monitored. This is the factory setting
and it is recommended that you use your
V955 in this mode.
BandsMOD
In this setting, your V955 will warn you
with an audible alert, and associated text
message stating which band has changed
from the original factory setting (i.e. “SWS
ON”). This warning is displayed during the
start up sequence (standard or fast).
Details of Programming