Britax Regent - Manual (Page 18)

32 33
Loosen the harness by lifting the harness 1
release lever while pulling the shoulder straps
forward as far as possible (Fig. A).
From the rear of the child seat, unhook 2
the shoulder harness straps from the yoke
(Fig. B).
Pull the harness straps through the shell, foam 3
and cover to the front of the child seat.
Thread the harness straps through the 4
appropriate harness slots in the cover, foam
and seat shell. (Fig. C).
Reattach harness straps to the harness yoke. 5
The buckle has two positions and
should be adjusted to fit your child
(Fig. A). Select the slot closest to, but not under,
the child.
Harness Height Adjustment Adjusting Buckle Position
A A
B
C
WARNING! HUGS ™ chest pads must be
used at all times.
Pull harness adjuster strap to tighten the 6
harness.
Verify that all straps are threaded at the 7
same height and are not twisted.
WARNING! Do not use position two (2)
until child exceeds 50 pounds (22.7 kg).
Remove the buckle, then rethread in appropriate position. See
page 36 for buckle removal and rethreading instructions.