Bissell 3590 User Manual
Page 5
5
This User’s Guide has been designed to help you get the most
satisfaction from your BISSELL CleanView. You’ll find assembly and
operating instructions, safety precautions, as well as maintenance and
troubleshooting instructions. Please read this User’s Guide thoroughly
before assembling your vacuum cleaner.
Pay particular attention to the product diagram, assembly
instructions, and part names. Locate and organize all parts
before assembly. Familiarize yourself with the parts and where
they fit. Following this User’s Guide will greatly enhance your
ability to get the most performance from your BISSELL
CleanView for many years.
The only tool you’ll need to assemble your vacuum
cleaner is a Phillips head screwdriver.
Locate the vacuum Handle and remove the screw packet
taped to the base of the Handle.
Stand the vacuum upright and slide the base of the Handle
firmly into the grooves at the top of the vacuum body.
Check to be sure the Handle is fitted to the vacuum
body. If there is a gap in front, continue to push firmly
until the Handle is flush.
Insert one screw provided from the screw packet into the
existing hole. Tighten securely with a Philliphs head screwdriver.
Position the Hose Assembly on the back of the vacuum
as shown.
Attach the Hose with the remaining two screws from the
packet. Tighten securely with a Phillips head screwdriver.
Grasping the Quick Reach Handle, slide the end of the
Hose Wand onto the Hose Wand Base. Snap the Hose
into the Hose Clip.
NOTE: The Powerfoot will not operate effectively
unless the Hose Wand is firmly attached.
Slide the Extension Wand and the Crevice Tool together
into the storage clip as shown.
Slide the Dusting Brush Tool into the storage clip as shown.
How To Use This Guide
How To Put It Together
W A R N I N G :
Plastic film can be dangerous.
To avoid danger of suffocation,
keep away from babies
and children.
Attach Handle To Vacuum
1.
2.
3.
4.
Attach Vacuum Hose and Tools
1.
2.
3.
4.
5.
ug603-5202/3590/220-240v/1/03 7/1/04 11:15 AM Page 5