Bissell 3590 - Manual (Page 8)

8
The Dirt Container needs to be emptied when the dirt
reaches the “Full” line on the side of the Container.
Unplug cleaner from electrical outlet.
Slide the Lock ‘n Seal Lever to the "Unlock" position.
Grasp handle and pull the Dirt Container straight out to
remove from vacuum.
Empty dirt into garbage container.
Put the Dirt Container back in the vacuum and slide the
lever to the "Lock" position.
Note: The Dirt Container may be washed in warm
water with a mild detergent. Make sure it is
completely dry before using again.
Use only BISSELL Replacement Filters in your BISSELL Cleanview.
Upper Tank Filter
203-1085
Unplug the cleaner from electrical outlet.
The Upper Tank Filter can be reached by removing the
Dirt Container, reaching underneath the Upper Tank and
turning the rim of the Filter Frame to unlock. Pull straight
down to remove. Brush the dirt off the Louvers and
Upper Tank Filter.
The foam Upper Tank Filter may be removed and hand
washed in cold water with mild detergent. Rinse well
then air dry thoroughly before replacing.
The Upper Tank and Louvers may also be wiped clean
with a damp cloth.
Note: For easier access, the entire Upper Tank
may be removed by turning the knob on the back
of the cleaner to unlock and pulling the entire
tank straight out.
Use only BISSELL Replacement Filters in your BISSELL CleanView.
Pre-Motor Filter
203-1073
Post-Motor Filter 203-1009
HEPA Media Post-Motor Filter 32076 (Optional Item)
Unplug the cleaner from electrical outlet.
The Pre-Motor Filter protects the motor from dirt particles.
It is located in the slide out tray underneath the Dirt
Container. If the filter becomes dirty, pull out the tray, lift
out the filter and clean.
Tip:
For maximum
cleaning performance,
check and clean or
replace all filters
as suggested.
Cleaning The Upper Tank & Filter
1.
2.
3.
Empty Dirt Container
1.
2.
3.
4.
Full Line
Lock Position Unlock
Position
4.
5.
Cleaning The Pre-Motor and Post-Motor Filters
1.
2.
W A R N I N G :
Do Not operate cleaner
with damp or wet
filters or without all
filters in place.
Post-Motor
Filter
Pre-Motor
Filter
ug603-5202/3590/220-240v/1/03 7/1/04 11:15 AM Page 8