BT paperjet 50 - Manual (Page 22)

Receiving faxes
By pressing the RX MODE button you can
set your PaperJet 50 to receive a document
in four different ways:
Press to display the following settings.
AUTOMATIC RX – This is Automatic reception.
Your fax machine automatically answers fax
calls (this is the default setting).
TAD FAX – This is the receive mode to use
if you want to use your machine in
conjunction with a telephone answering
machine to enable you to take fax and voice
messages.
MANUAL RX – This is Manual reception.
You answer calls in person and receive faxes
by pressing the Start button if you hear the
fax tones.
PHONE/FAX RX – This is Automatic reception
with call recognition. After the set number
of rings (default 2), your fax machine will
answer the call. If it is a fax, it is received.
If it is a voice call the machine beeps for up
to 20 seconds and the display shows
LIFT
HANDSET . If you do not lift the handset the
machine prepares to receive a fax.
If you pick up the phone before your
machine takes the call and you hear fax
tones, press the Start button to begin
reception and hang up the handset.
PaperJet 50 user guide – Edition 3 – 29.8.00
20
CANCEL – the machine cancels the
memory setting and returns to standby.
CHANGE PARAM? – you can change the
fax number and time settings. Display
shows
TYPE TIME .
Change the time if required.
Display shows TYPE NUMBER and the
number already entered.
You can change the number if required.
Repeat the 2 steps above for all the numbers
that have been entered.
Display shows TYPE FAX NUMBER .
Enter a new number if required.
Repeat the last step until you have entered
all the numbers you want up to a maximum
of 10.
After entering your last number press Start
again to confirm. Display shows
AUTOMATIC RX (or current receive mode)
and MEMORY TX .
0-9
0-9
0-9
Start
Start
Start
RX Mode
Start
PaperJet 50 User Guide 26/7/01 10:19 am Page 20