Bodyguard T360 - Manual (Page 30)

30
Deck Surface
The running deck needs to remain free of any loose items that may become trapped between the running belt and the
rollers. Avoid dropping liquids on the deck as this may cause the impregnated wax to gum up and collect at the rollers.
Under extreme conditions resulting in heavy wear and tear on the deck surface, it may be necessary to remove the deck and
turn it over, or turn it back-to-front to expose a fresh coat of wax. The deck is specially designed to offer four reversible sides
that have new or reduced wax surface wear.
Please contact your Bodyguard ® Dealer for servicing the deck.
Make certain to have the power off before doing any
maintenance.
1 - Breaker
2 - ON/OFF switch
3 - Power inlet
Drive motor with connection wires.
1 - Speed sensor cable
2 - Computer power cable
3 - Computer DATA cable
4 - Elevation motor cable
5 - Power AC cable
6 - Motor cable
Lubricant application
1. Clean the deck surface and the inside part of the belt with a dry piece of
fabric. Clean the belt first by using a long piece of fabric across the belt and
start the belt so it makes two complete turns. Then, release the tension on
the rear roller to be able to clean the deck surface of any debris or remaining
wax.
2. Open the lubricant supplied by your dealer. Place the lubricant tube in the
middle of the belt at about 15 inches from the hood cover. Step on the
treadmill and step down with your feet where the lubricant tube is located
under the belt to make sure that most of the lubricant is now spread evenly
on the deck surface. DO NOT START THE TREADMILL YET.
3. Remove the LUBE TUBE from under the belt and put the tension back again
on the rear roller. Stand where you applied the lubricant and press JUSTGO
to start the belt turning at 0.5 MPH (or 0.8 KMH). Let the belt bring you a the
back of the treadmill and come back where you were standing. Do this
twice so the lubricant will be present on the total surface of the deck. Start
the treadmill and make sure the belt alignment is correct. Refer to the owner’s
manual if any problem occurs.
BEST ZONE
1
2 3
4 5
6
figure 11 figure 11
Motor in treadmill for International models
1
2
3 4
5
6
Motor in treadmill for American models
2 3
1
figure 10